Deere 600FD Flexible Draper Active Header Height Control Quick Reference Guide

This guide describes the compatibility of 600FD Flexible Draper Platforms with John Deere 70 Series STS and John Deere S-Series Combines. It introduces basic setup and troubleshooting. It also introduces calibration procedures and a sensor voltage map.


Deere 600FD Flexible Draper Active Header Height Control Quick Reference Guide - cover page
Brand
DEERE
Category
Other
Document type
Quick Start Guide
Language
English
Pages
2
File format
PDF
File size
2.3 MB
Published
18 October, 2023
Updated
18 October, 2023
MD5 checksum
C0683DFF2D95C8CD91E2D2C2EA097104

About this manual

This document serves as a quick reference guide for the Deere 600FD Flexible Draper Active Header Height Control (AHHC) system. It provides essential information for operators regarding the setup and operation of the system on John Deere S-Series Combines and 70 Series STS combines. The guide details the compatibility of the 600FD platform with various combine models and outlines the specific sensor voltage requirements for proper function.

What's inside

  • Sensor Voltage Map
  • AHHC Mode Options
  • Calibrations
  • Troubleshooting
  • Sensor Voltage Settings
  • Adjustments
  • Belt Speed Adjust
  • Hydraulic Feeder House Fore/Aft Tilt Adjust
  • Side Belt Speed Reduction Switch
  • Float Arm Brackets

Specifications

Operating range of AHHC Sensors0.5 – 4.5 volts
Recommended sensor voltage setting0.9 – 4.1 volts
Minimum sensor voltage for calibration1.2 V

Frequently asked questions

What are the two unique Active Header Height Sensing (AHHS) modes for Flex Draper?

The two modes are On-ground (flex mode) for crops like soybeans and lentils, and Off-ground (rigid mode) for crops like wheat and barley.

What is the recommended voltage range to ensure the sensor does not shift out of the operating range?

It is highly recommended to set the sensors at 0.9 – 4.1 volts.

What causes a Header Calibration to fail?

Common causes include sensors out of range, damaged wiring harness, broken sensors, lock-out brackets still installed, or off-ground sensor arms pinned up.

Download PDF (2.3 MB)