TruTrak Flight Systems DigiFlight II Series Autopilots Installation Manual

About this manual

This manual provides step-by-step installation instructions for the DigiFlight II Series autopilots, including mechanical considerations for servo mounting, electrical wiring guidelines, and GPS setup procedures. It also covers ground checkout and first flight preparation to ensure safe operation. The document emphasizes critical safety precautions, such as proper servo alignment and avoiding RF interference, to prevent loss of aircraft control.

What's inside

• Mechanical Considerations
• Pitot / Static Connections
• RFI / EMI Considerations
• DigiFlight II Series Ground Checkout
• DigiFlight II Series First Flight
• GPS Setup Guide
• Garmin 430W and 530W
• Magnetic Considerations Supplement
• Definitions
• RETURN MERCHANDISE POLICY AND PROCEDURE

Frequently asked questions

What is the maximum recommended viewing angle for the DigiFlight II programmer unit?

The maximum recommended viewing angle should be no more than 20 degrees.

What wire gauge is required for all connections unless otherwise specified?

You must use AWG #24 or larger wire for all connections.

What is the most commonly used baud rate for the GPS receiver connected to pin 17?

The value of 9600 is the most commonly used rate.