Clifford Arrow 3 Car Alarm System Installation Manual

About this manual

This manual provides step-by-step instructions for installing the Clifford Arrow 3 car alarm system. It details component placement, wiring connections, and programming for remote controls and features like siren, door locks, and immobilizer. The system includes a control unit, siren, sensors, and remotes, with options for valet mode and smart auto-testing. Installation requires careful wiring and testing to ensure proper operation.

What's inside

• System Components
• Wiring Description for the 20-pin Connector
• Passenger Compartment Connections
• Engine Bay Connections
• Remote Control Operation
• Installer-Programmable Features

Frequently asked questions

What components are included in the Arrow 3 installation kit?

The kit includes one prewired 20-pin connector harness, one high output siren, one Arrow 3 control unit, one PlainView 2 coded valet switch, one hardware kit, one prewired LED, one piezo sensor, one user’s manual, two remote transmitters, two Clifford window decals, and one extended range receiver.

Where should the Arrow 3 control unit be installed?

The control unit must be installed inside the vehicle, not under the hood or in any hostile environment.

What is the maximum number of Clifford ACG 2 remote controls that can be programmed into the Arrow 3?

Up to a total of four Clifford ACG 2 remote controls can be programmed into the Arrow 3.

What is the current limit for the Accessory Output A?

The current is limited to 0.15 amp.