Franklin Electric SubDrive75/100/150/300 MonoDrive/MonoDriveXT Constant Pressure Controller Installation Manual

This manual provides instructions for installing the SubDrive75/100/150/300 MonoDrive and MonoDriveXT constant pressure controllers.


Franklin Electric SubDrive75/100/150/300 MonoDrive/MonoDriveXT Constant Pressure Controller Installation Manual - cover page
Brand
Franklin Electric
Category
Other
Document type
Installation Guide
Language
English
Pages
48
File format
PDF
File size
6 MB
Published
16 October, 2023
Updated
16 October, 2023
MD5 checksum
F4E58AD482D243BAF815B2E8D57D1005

About this manual

This manual provides installation instructions for the Franklin Electric SubDrive and MonoDrive series constant pressure controllers. These devices are designed to enhance the performance of standard submersible pumps by eliminating pressure cycling and providing consistent water pressure. The SubDrive models utilize three-phase motors to boost pump efficiency, while the MonoDrive models are optimized for retrofitting existing single-phase 3-wire systems.

What's inside

  • Description and Features
  • Included Items
  • How It Works
  • Pump Sizing and Drive Configuration
  • Underload Sensitivity
  • Steady Flow Selection
  • System Run Relay
  • Installation Procedure
  • Wiring Connections
  • Specifications

Specifications

Pressure Range25-80 psi (1.7-5.4 bar)
Motor Start-up CurrentLow (soft-starting)
Power Factor CorrectionActive
SubDrive75 Motor Rating1.5 hp (1.1 kW)
MonoDriveXT Motor Rating1.5 hp (1.1 kW)

Frequently asked questions

Who should install this equipment?

This equipment is intended for installation by technically qualified personnel.

What safety precaution is required before working on the system?

Power must be disconnected before working on or around the water system.

Can the SubDrive75 run a 1.0 hp or 1.5 hp pump?

Yes, it can be configured to run a 1.0 hp or 1.5 hp pump using DIP switch SW1.

Download PDF (6 MB)