The DYNAMIC PERFORMANCE TRIGGER is a trigger upgrade for WALTHER firearms. It can be installed using special tools.
The manual explains how to safely install the Dynamic Performance Trigger upgrade on Walther pistols. It includes safety warnings, a list of required tools, and detailed disassembly and reassembly steps for both steel and polymer frames.
Key sections cover frame disassembly, installation of the locking block and slide release, and a final function check to verify proper operation after the upgrade.
| Drift punch size | 3 mm |
|---|---|
| Screwdriver size (polymer frame) | 2.5 mm |
The recommended tools are a 300 g hammer, plastic mallet, two wooden blocks (≈20 × 30 × 100 mm), a 2.5 mm screwdriver (polymer frames only), 2 mm and 3 mm drift punches, and gun lubricant.
Ensure the pistol and magazine are unloaded, insert an empty magazine, retract the slide, verify the slide stop lever locks, then pull the trigger while racking the slide to confirm the sear engages and listen for an audible click when the striker falls.
Yes, the manual includes a separate section with polymer‑frame specific steps for removing and installing the locking block, slide release, and trigger components.