This manual explains safety precautions for the DAR-100, including keeping the unit away from water, using it in a well‑ventilated area, and never opening the enclosure. It also describes the front‑panel controls such as the reverb control knob (delay/repeat), volume, tone, and source selection, as well as the rear‑panel connectors for power, audio, video and external remote sensors.
Installation guidance covers proper power connection (AC220V/50Hz in China, AC230V in Singapore, AC240V in Malaysia), avoiding overload, and correct speaker wiring. The specifications section lists the amplifier’s 80W+80W output, frequency response, power consumption, dimensions, weight and other key parameters. This manual is written in Chinese.
| Power Output | 80W+80W |
|---|---|
| Frequency Response | 90Hz‑25kHz ±3dB |
| Power Supply (China) | AC220V/50Hz |
| Power Consumption | 240W |
| Maximum Output Power (Socket) | 200W |
| Dimensions | 420 mm × 126.5 mm × 385 mm |
| Weight | 8.8 kg (19.4 lb) |
| Video Input Sensitivity / Impedance | 1 Vpp / 75 Ω |
| Video Output Sensitivity / Impedance | 1 Vpp / 75 Ω |
Do not use the unit near water, keep it in a well‑ventilated area away from heat sources, never open the enclosure, and disconnect power before any maintenance.
Use the reverb control knob; turning clockwise increases delay or repeat, while turning counter‑clockwise decreases them.
The unit requires AC220V/50Hz in China, AC230V/50Hz in Singapore, and AC240V/50Hz in Malaysia.
The amplifier measures 420 mm × 126.5 mm × 385 mm and weighs 8.8 kg (19.4 lb).