PADAUK PMC234 Series User Manual

This document is the user manual for the PMC234 series, which introduces the IO usage and settings, interrupt usage steps, and other information of the PMC234 chip.


PADAUK PMC234 Series User Manual - cover page
Brand
PADAUK
Category
microcontrollers
Document type
User Manual
Language
Chinese
Pages
4
File format
PDF
File size
157 KB
Published
03 December, 2022
Updated
28 September, 2023
MD5 checksum
CC4F4D028B50EA513E2F5D4B197341E9

About this manual

The document serves as a guide for users of the PMC234 Series microcontrollers, highlighting common mistakes to avoid. It details specific configurations for Input/Output (IO) pins, including setting them as analog inputs or digital inputs with wake-up functions, and notes that PA5 can only function as an open-drain output requiring external pull-up resistors.

Key operational topics include interrupt handling restricted to the FPPA0 core, procedures for safely switching system clock sources between ILRC, IHRC, and EOSC without causing a hang, and specific timing requirements when using the External Oscillator (EOSC). The manual also covers power-down modes, watchdog timer behavior relative to wake-up functions, TIMER overflow characteristics, ADC usage constraints regarding frequency and impedance, Low Voltage Reset (LVR) voltage thresholds, and instruction cycle differences between single-core and dual-core modes. This manual is written in Chinese.

What's inside

  • IO Usage and Settings
  • Interrupts
  • System Clock Switching
  • Power-down Mode and Watchdog
  • TIMER Overflow Time
  • ADC Usage Precautions
  • LVR (Low Voltage Reset)
  • Single/Dual Core Instruction Cycles

Frequently asked questions

What is the minimum VDD voltage required for the PMC234 to start up?

The power supply voltage must exceed 2.2V at Power On for the chip to successfully start.

What is the recommended maximum conversion frequency for the ADC?

The manual suggests a maximum ADC conversion frequency of 500kHz.

How many times must TIMER2 overflow to generate an interrupt when set in 6-bit mode?

When configured for 6-bit mode, an interrupt occurs after four overflows of TIMER2.

Download PDF (157 KB)

More PADAUK Manuals


View all PADAUK manuals →