The Four Function Spa Side Remote is a double insulated, submersible device which is ETL listed (to UL Standard 1563) for installation at the water's edge. It is typically installed at the tile-line of the spa wall, or in the deck within arm's reach of the spa. It can be used with a gunite spa, acrylic spa, or hot-tub. When installing the Four Function Remote, it is important to make provisions for this hard-wired remote before the pool/spa construction is complete by running electrical conduit from the desired remote location to the future Power Center location. Do not install the Four Function Remote until construction of spa and deck is complete.
This document provides installation instructions for the Jandy Four Function Spa Side Remote, a double-insulated, submersible device designed for use with gunite, acrylic, or hot-tub spas. The remote is ETL listed to UL Standard 1563 and is intended for installation at the water's edge or within arm's reach of the spa.
The guide details two primary installation scenarios: mounting in a concrete or tile wall and mounting in a spa shell or wood deck. Both methods require running electrical conduit from the remote location to the AquaLink RS Power Center before construction is complete. The instructions cover specific steps for installing PVC piping, running conduit with sweep elbows, wiring the remote at the Power Center, and securing the device in its housing.
| Insulation Type | Double insulated |
|---|---|
| Listing Standard | ETL listed (to UL Standard 1563) |
| Minimum Pipe Size | 6" (minimum) |
| Conduit Size | 2" or 3/4" |
This product must be installed and serviced by a professional pool/spa service technician.
Do not install the remote until the construction of the spa and deck is complete.
Sweep elbows should be used for turns so that the remote cable can be easily pulled later.