Sta-Rite Appliance Adapter and Metal Flue Collar Installation Guide

About this manual

This document provides a step-by-step procedure for bonding an appliance adapter or metal flue collar to a vent body. The process involves surface preparation with isopropyl alcohol, applying UltraCopper Silicone RTV, and mechanically securing the joint with sheet metal screws. Users must allow the adhesive to cure for at least 24 hours before operating the heater.

What's inside

• Surface Preparation
• Applying RTV
• Assemble the metal flue collar
• Install screws
• Connect the vent pipe
• Test joint
• Curing time

Frequently asked questions

What solvent is recommended for degreasing the bonding surfaces?

Use isopropyl alcohol to degrease the bonding surfaces, but do not use any flammable solvent near fire or flame.

How long must the joint cure before firing the heater continuously?

Allow the joint to cure at least 24 hours before continuously firing the heater or putting stress on the joint.

What is the maximum time allowed for testing the joint after assembly?

Test the joint by firing the heater for one minute or less and checking for leaks.