This document provides some general tips on pump installation, including where to place the pump, how to run the suction line, and how to connect the pipes.
This guide provides general tips for installing an All Max-Flo pump, such as locating it close to the pool to reduce friction loss in suction lines. It specifies that pipe connections should not be overtightened and recommends using sealants like Teflon tape or Permatex No. 2 specifically formulated for plastics.
This pump is U.L. listed for permanently installed pools and may also be used with hot tubs and spas if so marked.
You must use a #8 AWG conductor to connect the motor with other bonding parts.
Allow a reasonable time for priming, such as five minutes.