This document is the user manual for XNET Utility Program, which describes the system requirements and installation steps of XNET IP Installation Wizard, as well as the methods for VS/NC setup and router setup using XNET Utility Program.
This manual guides first‑time users of the XNET IP Installation Wizard through system requirements, software setup, and network configuration. It explains how to assign IP addresses to Video Servers (VS) or Network Cameras (NC), and how to use the wizard’s VS/NC Setup and Router Setup functions.
The document also lists supported routers for DMZ or port‑forwarding, details the end‑user license agreement, and includes troubleshooting notes such as warnings about existing router settings. It is intended for users connecting XNET video servers or network cameras to client programs on Windows PCs.
| Recommended CPU | 300 MHz or faster |
|---|---|
| Recommended RAM | 128 MB or more |
| Supported Operating Systems | Windows XP and Windows Vista |
| Supported Routers | Anygate RG-3500A, IPTime G104, Linksys WRT54GC, Netgear KWGR614, Belkin 4.03.03 |
The wizard requires a CPU of 300 MHz or faster, at least 128 MB of RAM, and runs on Windows XP or Windows Vista.
Run the VS/NC Setup in the wizard, select the device from the list (or use manual setup), then enter the desired IP address, subnet mask, gateway, HTTP port, and RTSP port.
Supported routers include Anygate RG‑3500A, IPTime G104, Linksys WRT54GC, Netgear KWGR614, and Belkin 4.03.03.