This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna -Move the equipment away from the receiver -Plug the equipment into an outlet on a circuit different from that to which the receiver is connected -Consult the dealer or an experienced radio/television technician for additional suggestions You are cautioned that any change or modifications to the equipment not expressly approved by the party responsible for compliance could void Your authority to operate such equipment. This device complies with part 15 of the FCC Rules. Operation is subjected to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.
This manual provides the complete documentation for the 6WMZ7 Series Intel 810 Socket 370 motherboard. It is organized into sections such as revision history, item checklist, feature summary, hardware setup, BIOS configuration, and appendices.
The guide details the motherboard’s form factor, supported CPU socket, chipset, memory types, expansion slots, on‑board peripherals, and safety compliance information, helping users install and operate the board safely and efficiently.
| Form factor | Micro ATX (24.6 cm × 21.1 cm) |
|---|---|
| CPU socket | Socket 370 |
| Chipset | Intel GMCH82810 |
| Memory slots | 2168‑pin DIMM, PC‑100 SDRAM 16 MB‑512 MB, 3.3 V |
| Supported memory | PC‑100 SDRAM, 16 MB‑512 MB, 3.3 V |
| Expansion slots | 1 AMR, 3 × 32‑bit PCI, 1 × TVDFP, optional 16‑bit ISA |
| On‑board IDE | Supports up to four IDE devices |
| Ports | 1 Parallel, 2 Serial (COM), 2 USB |
It is a Micro ATX board measuring 24.6 cm by 21.1 cm.
The board uses an Intel Socket 370 processor socket.
Up to four IDE devices can be attached to the on‑board IDE controller.
It supports PC‑100 SDRAM DIMM modules from 16 MB to 512 MB, operating at 3.3 V.