This manual introduces the use, installation, and maintenance instructions for the KC type, KCL type pressure rotary joints
This manual provides detailed instructions for installing, operating, and maintaining Pearl rotary joints (pressure rotary connectors) of the KC and KCL types. It covers preparation, proper piping methods, correct installation steps, seal maintenance, lubrication, and handling of abnormal conditions.
Safety warnings, recommended hose lengths, and procedures for disassembly, inspection, and part replacement are included to ensure reliable and safe operation of the rotary joints. This manual is written in Chinese.
| Recommended hose length for 20A | 300–400 mm |
|---|---|
| Recommended hose length for 25A | 400–600 mm |
| Recommended hose length for >32A | 600–800 mm |
| Allowed hose material | Soft hose or rubber hose only |
The ventilation hole must face downward to allow any leaked fluid to drain and avoid accumulation inside the housing.
Use a soft hose or rubber hose; steel pipe should not be used for direct piping.
For 20 A use 300–400 mm, for 25 A use 400–600 mm, and for 32 A or larger use 600–800 mm.
Immediately close the valve, stop fluid flow, shut down the machine, and repair or replace the affected parts.