This manual describes the HS‑CON216 16E1/100BaseT converter, a device that transports Ethernet MAC frames over 1‑16 E1 lines with a maximum transmission rate of 34 Mbps. It details system architecture, technical features, panel definitions, indicator lights, switch settings, and test procedures.
The document also covers cable preparation, chassis dimensions, power requirements, installation steps, and maintenance guidelines, helping users safely integrate the converter into point‑to‑point or optical network environments. This manual is written in Chinese.
| Supported E1 channels | 1‑16 |
|---|---|
| Ethernet interface | 100 Mbps MII, full‑duplex |
| Maximum transmission rate | 34 Mbps |
| Power supply options | ~220 V AC or -48 V DC |
| Maximum packet size | 2036 bytes |
| Flow control | PAUSE supported |
| UART address capacity | Up to 256 devices |
| Chassis dimensions | 483 mm × 44.45 mm × 200 mm |
It supports 1 to 16 E1 channels for Ethernet data transport.
The device can be powered by either ~220 V AC or -48 V DC, but not both simultaneously.
A crossover Ethernet cable should be used for PC connections.
No, supplying both AC and DC simultaneously will damage the power supply.