Industrial

The NC7S14 is a single high performance CMOS Inverter with Schmitt Trigger input. The circuit design provides hysteresis between the positive-going and negative going input thresholds thereby improving noise margins. Advanced Silicon Gate CMOS fabrication assures high speed and low power circuit operation over a broad VCC range. ESD protection diodes inherently guard both input and output with respect to the VCC and GND rails.

NC7S04 is a single high-performance CMOS inverter. Advanced Silicon Gate CMOS fabrication assures high speed and low power circuit operation over a broad VCC range. ESD protection diodes inherently guard both input and output with respect to the VCC and GND rails. Three stages of gain between input and output assures high noise immunity and reduced sensitivity to input edge rate.

The NC7NZU04 is a triple unbuffered inverter from Fairchild's Ultra High Speed Series of TinyLogic. The special purpose unbuffered circuit design is primarily intended for crystal oscillator or analog applications. The device is fabricated with advanced CMOS technology to achieve ultra high speed with high output drive while maintaining low static power dissipation over a very broad VCC operating range. The device is specified to operate over the 1.65V to 5.5V VCC range.

The NC7NZ14 TinyLogic UHS Inverter with Schmitt Trigger Input is a high-performance logic chip released by Fairchild Semiconductor Corporation. It is manufactured using CMOS technology and has ultra-low power consumption, ultra-high speed, and high output drive. The chip's VCC operating voltage range is 1.65V to 5.5V, and the input and output are in a high impedance state when VCC is 0V. The input can tolerate up to 7V of voltage regardless of the VCC operating voltage.

The NC7NP14 is a triple inverter with Schmitt trigger input from Fairchild's Ultra Low Power (ULP) Series of TinyLogic®. Ideal for applications where battery life is critical, this product is designed for ultra low power con- sumption within the VCC operating range of 0.9V to 3.6V VCC. The internal circuit is composed of a minimum of inverter stages, including the output buffer, to enable ultra low static and dynamic power. The NC7NP14 is designed for optimized power and speed, and is fabricated with an advanced CMOS tech- nology to achieve high speed, low noise operation while maintaining extremely low CMOS power dissipation.

The NC7NP04 is a triple inverter from Fairchild's Ultra Low Power (ULP) Series of TinyLogic®.

The MM74HCU04 is a hex inverter. It utilizes advanced silicon-gate CMOS technology to achieve operating speeds similar to LS-TTL gates with the low power consumption of standard CMOS integrated circuits. It has high noise immunity and the ability to drive 15 LS-TTL loads.

MM74HCT05 is a six-transistor open drain inverter manufactured by Fairchild Semiconductor Corporation. It has LS-TTL pinout and threshold compatibility, a maximum load current of 10 LS-TTL loads, and typical propagation delays of tPZL (1kΩ resistor) 10ns and tPLZ (1kΩ resistor) 8ns.

The MM74HCT04 is a hex inverter manufactured by Fairchild Semiconductor. It has TTL, LS pin-out and threshold compatibility, fast switching, low power, high fanout, inversion, and triple buffering.

The 74VHCU04 is a hex inverter with high speed, low power dissipation, and high noise immunity. It is fabricated with silicon gate CMOS technology and is pin and function compatible with 74HCU04.

The VHCT14A is an advanced high speed CMOS Hex Schmitt Inverter fabricated with silicon gate CMOS technology.

This document describes the features and characteristics of the 74VHCT04A hex inverter produced by Fairchild Semiconductor Corporation, including high-speed operation, high noise immunity, low power dissipation, etc.