Industrial

The Fairchild Switch FSTU32160 is a 16-bit to 32-bit high-speed CMOS TTL-compatible multiplexer/demultiplexer bus switch. The low on resistance of the switch allows inputs to be connected to outputs without adding propagation delay or generating additional ground bounce noise. The device can be used in applications where two buses need to be addressed simultaneously. The FSTU32160 is designed so that the A Port demultiplexes into B1 or B2 or both. The A and B Ports have “undershoot hardened” circuit protection to support an extended range to 2.0V below ground. Fairchild’s integrated Undershoot Hardened Circuit (UHC®) senses undershoot at the I/O’s, and responds by preventing voltage differentials from developing and turning on the switch. Two select (S1, S2) inputs provide switch enable control. When S1, S2 are HIGH, the device precharges the B Port to a selectable bias voltage (Bias V) to minimize live insertion noise.

NC7SB3257 is a 2:1 NMOS passgate multiplexer/demultiplexer produced by Fairchild Semiconductor Corporation. The device is fabricated with advanced sub-micron CMOS technology to achieve high speed enable and disable times and low On Resistance. The device is specified to operate over the 4.0 to 5.5V VCC operating range. The control input tolerates voltages up to 5.5V independent of the VCC operating range.

The NC7SZ384 is a 1-bit ultra high-speed CMOS TTL-compatible bus switch with features such as low resistance, minimal propagation delay, and zero bounce.

The NC7SZD384 is a low power, 1-bit TTL compatible bus switch with 5V to 3.3V level shifting capability.

The NC7WB3125 is a 2-bit ultra high-speed CMOS FET bus switch with TTL-compatible active LOW control inputs. The low On Resistance of the switch allows inputs to be connected to outputs with minimal propagation delay and without generating additional ground bounce noise. The device is organized as a 2-bit switch with independent bus enable (OE) controls. When OE is LOW, the switch is ON and Port A is connected to Port B. When OE is HIGH, the switch is OPEN and a high-impedance state exists between the two ports. Control inputs tolerate voltages up to 5.5V independent of VCC.

NC7WBD3125 2-Bit Low Power Bus Switch with Level Shifting

The 407907 Heavy Duty RTD Thermometer is a heavy duty RTD thermometer produced by Extech. It features high accuracy and wide temperature range, and can measure temperature from -199.99 to 1562.0°F (-199.99 to 850.0°C) with resolution of 0.1° or 0.01°.

The document describes the TAS5111, a high-performance digital amplifier power stage designed to drive a 4-Ω speaker with a maximum output power of 70W. The device utilizes TI's PurePath Digital technology and is used in conjunction with a digital audio PWM processor (TAS50XX) and a simple passive demodulation filter to achieve high-quality, high-efficiency digital audio amplification. The efficiency of this amplifier can exceed 90%, depending on the system design. The TAS5111 incorporates overcurrent protection, overtemperature protection, and undervoltage protection to safeguard the device and speakers against fault conditions that could damage the system.

FAN6751 is a highly integrated PWM controller produced by Fairchild Semiconductor. It has multiple features to enhance the performance of LCDM/TV, NB and adapters. The green-mode function includes off-time modulation and burst mode to reduce the PWM frequency at light-load and in no-load conditions. To avoid acoustic noise problems, the minimum PWM frequency is set above 18KHz. This green-mode function enables the power supply to meet international power conservation requirements. With the internal high-voltage startup circuitry, the power loss due to bleeding resistors is also eliminated. Built-in synchronized slope compensation achieves stable peak-current-mode control. The proprietary external line compensation ensures constant output power limit over a wide AC input voltage range, from 90VAC to 264VAC. FAN6751 provides many protection functions, as shown in Table 1. In addition to cycle-by-cycle current limiting, the internal open-loop protection circuit ensures safety should an open-loop or output short-circuit failure occur.

The TAS5112 is a high-performance, integrated stereo digital amplifier power stage designed to drive 6-Ω speakers at up to 50 W per channel.

This application note describes a detailed design strategy for higher-power conversion efficiency and better EMI using a Quasi-Resonant PWM controller compared to the conventional, hard-switched converter with a fixed switching frequency. Based on the proposed design guideline, a design example with detailed parameters demonstrates the performance of the controller.

This document describes the features and characteristics of the audio power amplifier model SLES094A, including 50W output power per channel, 95dB dynamic range, low distortion rate, etc.

FAN6204 is a synchronous rectification controller suitable for CCM / DCM / QR flyback converters and dual-switch forward free-wheeling rectification.

This application note introduces the design guidelines for the FAN6754A PWM controller, which features green mode, frequency hopping, constant power limit, and various protection functions. The power supply can meet stringent standby power regulations by maximizing light-load efficiency, and frequency hopping reduces electromagnetic emission. The constant-power-limit function minimizes component stress in abnormal conditions, and integrated protection functions improve reliability without increasing system cost. This application note explains how to replace the SG6742 PWM controller with the FAN6754A and provides a summary of the differences between the two devices.