Industrial

AD1837 is a 2-channel ADC and 8-channel DAC audio codec from Analog Devices, supporting 96kHz sample rate and 16/20/24-bit word length.

AD1819B is an AC'97 audio codec from ADI, supporting multiple audio input and output, with high SNR, high sampling rate and multiple features.

1 phase full wave bridge rectifiers

1 PHASE FULL WAVE BRIDGE RECTIFIERS SCBAR05 SCBAR1 SCBAR2 SCBAR4 SCBAR6 SCBAR8 SCBAR10

This is a product manual

1 phase full wave bridge rectifiers SCBA05F, SCBA1F, SCBA2F, SCBA4F datasheet

ISL4221E and ISL4223E are Intersil's QFN packaged, +/-15kV ESD protected, +2.7V to +5.5V, 150Nanoamp, 250kBps RS-232 transmitters/receivers.

FN6201.1 ISL81387, ISL41387 ±15kV ESD Protected, Dual Protocol (RS-232/RS-485) Transceivers. These devices can be configured as either a single RS-422/485 differential transceiver or a dual (2 Tx, 2 Rx) RS-232 transceiver. They support both RS-232 and RS-485/RS-422 communication standards, and have many features and functions.

ISL81334, ISL41334 ±15kV ESD Protected, Two Port, Dual Protocol Transceivers

ISL81334, ISL41334 ±15kV ESD Protected, Two Port, Dual Protocol Transceivers The ISLX1334 are two port interface ICs where each port can be independently configured as a single RS-485/422 transceiver, or as a dual (2 Tx, 2 Rx) RS-232 transceiver. With both ports set to the same mode, two RS-485/422 transceivers, or four RS-232 transceivers are available. If either port is in RS-232 mode, the onboard charge pump generates RS-232 compliant ±5V Tx output levels from a single VCC supply as low as 4.5V. Four small 0.1µF capacitors are required for the charge pump. The transceivers are RS-232 compliant, with the Rx inputs handling up to ±25V, and the Tx outputs handling ±12V. In RS-485 mode, the transceivers support both the RS-485 and RS-422 differential communication standards. The receivers feature "full failsafe" operation, so the Rx outputs remain in a high state if the inputs are open or shorted together. The transmitters support up to three data rates, two of which are slew rate limited for problem free communications. The charge pump disables when both ports are in RS-485 mode, thereby saving power, minimizing noise, and eliminating the charge pump capacitors. Both RS-232 and RS-485 modes feature loopback and shutdown functions. Loopback internally connects the Tx outputs to the corresponding Rx input, to facilitate board level self test implementation. The outputs remain connected to the loads during loopback, so connection problems (e.g., shorted connectors or

The ISL4089 is a complete DC-restored monolithic video amplifier sub-system. It contains a high performance video amplifier and a nulling, sample-and-hold amplifier designed to establish a programmable DC output level. When the HOLD logic input “0” is applied the DC restore function is active. The sample-and-hold amplifier loop is closed and used to null the DC offset of the video amplifier. This can occur during sync, or, at any time that a black level is expected. When the HOLD input “1” is applied, the correcting voltage is stored on the video amplifier’s input coupling capacitor. This condition must be true during active video. The restored DC voltage level can be adjusted using an external reference voltage applied to the VREF pin. The device operates from a single +5V supply and is ideal for +5V only systems when used with a sync separator, such as the EL1883. The ISL4089 is intended to directly replace the EL4089 only in certain applications. This direct replacement requires that the single positive supply is no higher than +5.5V and that no part of the clamped output goes below -0.5V.

The ISL3980 is a monolithic GaAs Power Amplifier designed to operate in the ISM band. It features two low voltage single supply stages which cascaded deliver 21dBm (Typ) output power. In addition, the device includes an integrated power detector which is accurate over a 15dB dynamic range within (±)1dB, which can be used to implement an accurate ALC function. The ISL3980 is housed in a 24 lead QFN package.

The Intersil ISL3886 Wireless LAN Integrated Media Access Controller with Baseband Processor is part of the PRISM Duette™, Dual Band radio chipset. The ISL3886 directly interfaces with Intersil’s ISL3692 Dual Band Direct Conversion transceiver. Adding Intersil’s ISL3092 10GHz VCO and Intersil’s ISL3992 Dual Band Power Amp completes an end-to-end WLAN Chipset solution compliant with 802.11a/b/g/h/i/j standards. The 802.11 protocol is implemented in firmware supporting custom WLAN solutions. Software implements the full IEEE 802.11 Wireless LAN MAC protocol. It supports BSS and IBSS operation under DCF, and operation under the optional Point Coordination Function (PCF). Active scanning is performed autonomously once initiated by host command. Host interface command and status handshakes allow concurrent operations from multi-threaded I/O drivers. Orthogonal Frequency Division Multiplexing (OFDM) of 52 sub-carriers