ST Manuals

The TDA7391LV is a bridge class AB audio power amplifier specially intended for car radio high power applications. It combines high power output with the possibility to operate either in differential input mode or single ended input mode. It is moreover compliant to the most recent OEM specifications for low voltage operation (so called 'start-stop' battery profile during engine start-stop).

This datasheet provides detailed information on the STPA001 4 x 50 W MOSFET quad bridge power amplifier, including its features, specifications, and applications.

L4954 is a quad output voltage regulator and a three output high side driver. The IC includes monitoring circuitry to warn the microprocessor of a low voltage condition: the LVWarn, output, sensing the slow dropping of STCAP pins voltage, gives the microprocessor time to store data. A reset output is generated at REG4’s decay. External protection must be provided for reverse battery protection.

The VND600P-E is a double channel high-side solid state relay with features including CMOS-compatible input, proportional load current sense, shorted load protection, undervoltage and overvoltage shutdown, overvoltage clamp, thermal shutdown, current limitation, protection against loss of ground and loss of VCC, very low standby power dissipation, and reverse battery protected.

VN5E006ASP-E is a single channel high-side driver with analog current sense and diagnostic functions for automotive applications.

VN5770AKP-E is a high performance, low power, small-sized quad smart power solid state relay from STMicroelectronics. The product uses STMicroelectronics' industry-leading VIPower® technology, which has high voltage resistance, low power consumption, low electromagnetic interference and other advantages, meeting the strict requirements of automotive electronics applications.

The VB525SP-E is a high voltage power integrated circuit made using the STMicroelectronics™ VIPower™ M1-3 technology, with Darlington and logic level compatible vertical current flow power driving circuit. The enable pin allows to externally block the switch when the input is on. A built-in protection circuit for coil current limiting and collector voltage clamping allows the device to be used as a smart, high voltage, high current interface in advanced electronic ignition systems. If the input signal from the microcontroller happens to remain high, the device protects itself against overheating by forcing collector current to smoothly decrease (low voltage clamp feature) to avoid undesired spark.

74V2T14 is a high performance CMOS triple schmitt inverter with high speed, low power and high anti-interference ability

74V2T132 is an advanced high-speed CMOS SINGLE 2-INPUT NAND GATE fabricated with sub-micron silicon gate and double-layer metal wiring C2MOS technology.

The 74V2T125 is a high-speed CMOS dual bus buffer produced by Texas Instruments. It features low power consumption, high output impedance, high electrostatic discharge capability, wide voltage range, and TTL output compatibility.

The 74V2T08 is a high-speed CMOS dual 2-input AND gate with low power dissipation, high noise immunity, and stable output. It can be used to interface 5V to 3V.

74V2T07 is a triple buffer with high noise immunity and stable output. It can be used to interface 5V and 3V.

The 74V2T05 is an advanced high-speed CMOS triple open drain inverter fabricated with sub-micron silicon gate and double-layer metal wiring C2MOS technology. It has high speed, low power consumption, high noise immunity, stable output and other features. The operating voltage range of the device is 4.5V to 5.5V, the input voltage range is -0.5V to 7V, and it can be used in 5V to 3V voltage.

The document describes the features and characteristics of the 74V2T04 triple inverter, including high speed, low power dissipation, compatibility with TTL outputs, etc.