ANALOG Manuals

AD9861 is a Mixed-Signal Front-End (MxFE™) Baseband Transceiver for Broadband Applications

AD9863 Rev. A is a mixed-signal front-end (MxFE™) baseband transceiver for broadband applications produced by Analog Devices.

AD9863 is a radio transceiver launched by Analog Devices. It supports 50Msps ADC and 200Msps DAC, has 1x, 2x, 4x interpolation and programmable gain control. The transceiver supports various half-duplex and full-duplex modes and can be programmed through register programming or limited programming through mode pins.

AD9864 is a general-purpose IF subsystem produced by Analog Devices. It is suitable for a variety of narrow-band radio products, such as UHF/VHF FDMA receivers, TETRA, APCO25, GSM/EDGE portable and mobile radio products, and SATCOM terminals.

AD9864 is a low-frequency signal acquisition chip launched by ADI. It uses a 48-lead LFCSP package and works at a voltage of 2.7V to 3.6V. It integrates LO and sampling clock generators and supports 16-bit or 24-bit serial digital output.

AD822 is a single-supply, rail-to-rail low power FET-input operational amplifier. It features true single-supply operation, output swings rail-to-rail, input voltage range extends below ground, single-supply capability from 3V to 36V, and dual-supply capability from ±1.5V to ±18V. It is suitable for battery-powered precision instrumentation, photodiode preamps, active filters, 12-bit to 14-bit data acquisition systems, medical instrumentation, and low power applications.

AD823 Rev. B is a dual, 16 MHz, Rail-to-Rail FET input amplifier with the following features: single-supply operation, output swings rail-to-rail, input voltage range extends below ground, single-supply capability from 3 V to 36 V, high load drive, excellent ac performance, good dc performance, low distortion and low noise.

AD8231 is a zero drift, digital programmable instrumentation amplifier with excellent temperature performance and DC performance. It is suitable for industrial control applications such as pressure transducers, strain transducers, thermocouples, and RTD temperature sensors.

AD8231 is a zero-drift, digital programmable instrumentation amplifier with features such as digitally programmable gain, excellent temperature performance, excellent DC performance, and good AC performance.

This document provides preliminary technical data on the AD8253 CMOS programmable gain instrumentation amplifier with features including small package, programmable gains, wide supply range, excellent DC and AC performance.

AD8231 is a digitally programmable instrumentation amplifier from Analog Devices with zero drift, high input impedance, wide bandwidth and high gain accuracy. It is suitable for pressure and strain transducers, thermocouples and RTDs, programmable instrumentation, industrial controls and weighing scales.

The AD8235 is the smallest and lowest power instrumentation amplifier in the industry. It is available in a 1.5 mm × 2.2 mm wafer level chip scale package (WLCSP). The AD8235 draws a maximum quiescent current of 40 μA. In addition, it draws a maximum 5...

This document describes the features and characteristics of the Analog Devices AD823 dual, 16 MHz, rail-to-rail FET input amplifier. It features single supply operation, output swings rail to rail, input voltage range extends below ground, and single supply capability from +3V to +36V. Additionally, it has high load drive capacity, low distortion, and low noise. The product can be used in battery-powered precision instrumentation, photodiode preamps, active filters, 12- to 16-bit data acquisition systems, and medical instrumentation.