Industrial

Mitsubishi PM100CLB060 is a 3-phase 100A, 600V intelligent power module that adopts a 5th generation CSTBT chip with excellent performance. The module uses a thin package that is 32% smaller and 22% thinner than the S-DASH series.

This document describes the features and characteristics of the May 2005 MITSUBISHI PM100CLA120 flat-base type insulated package. It adopts a new 5th generation IGBT (CSTBT) chip, which has improved performance. It is suitable for general purpose inverters, servo drives, and other motor controls.

PM100CLA060 FLAT-BASE TYPE INSULATED PACKAGE is a 3φ 100A, 600V Current-sense IGBT type inverter produced by Mitsubishi. It adopts 1µm fine rule process, has a low Vce(sat) characteristic, and integrates gate drive and protection logic. It can detect short-circuit, over-temperature, under-voltage, etc. faults and output fault information through P-Fo.

Powerex Intellimod™ Intelligent Power Modules are isolated base modules designed for power switching applications operating at frequencies to 20kHz. Built-in control circuits provide optimum gate drive and protection for the IGBT and free-wheel diode power devices.

The OP215 is a dual precision JFET-input operational amplifier produced by Analog Devices in the United States. It features high slew rate, low input bias current, low input offset voltage, and low input noise current.

The ADD8706 is a single-supply, 5-channel buffer with a separate VCOM amplifier that has been optimized for today’s low cost TFT LCD notebook and monitor panels. The top and bottom channels swing to the top/bottom rails, respectively, and can be used as end-point gamma references. The middle channels are ideal for midpoint gamma references. The VCOM amplifier has a peak output current of 250 mA and can drive high impedance loads.

AD9662 is a laser diode driver for high performance CD and DVD recordable drives. It includes three channels for three different optical power levels: the read channel generates a continuous output power level, whereas Channel 2 and Channel 3 are used as write channels having 0.8 ns rise/fall times. All channel currents are summed at the IOUT pin. Each channel’s output current is established by multiplying the channel’s input current and a current gain, where the current gain is controlled by the input current. The device is suitable for CD-RW, DVD-RW, DVD+RW and MO drives.

The AD8393 is a low power, high output current, single-supply, ADSL-CO line driver that features ADI’s patent pending Adaptive Linear Power architecture. It has 4 power modes, and can achieve over 36V p-p differential output while processing signals with occasional peaks.

The BB1 Series is an N type small signal transistor and enables the reduction of component counts and downsizing of sets due to on-chip resistors. This transistor is especially ideal for use in household electronic appliances and OA equipments such as VCRs and TVs.

The BB190 is a variable capacitance diode produced by Philips. It features excellent linearity, very small plastic SMD package, very low series resistance and very low capacitance spread. It is widely used in UHF radio tuners and VCO.

This document describes the features of LITE-ON TECHNOLOGY CORPORATION products, including high current transfer ratio, high input-output isolation voltage, and response time. It also provides detailed information on different models and packaging options.

The AD8013 is a low power, single supply, triple video amplifier. Each of the three amplifiers has 30 mA of output current, and is optimized for driving one back terminated video load. It features excellent video specifications (RL = 150 Ohms), gain flatness of 0.1 dB to 60 MHz, differential gain error of 0.02%, and differential phase error of 0.06°.

The OP220 is a monolithic dual operational amplifier that can be used either in single or dual supply operation. Its low offset voltage and input offset voltage tracking (as low as 1.0 mV/∞C) make it the first micropower precision dual operational amplifier. Its excellent specifications make it very attractive in portable applications.