corcom Manuals

The K series RFI power line filters are general purpose common-mode and differential-mode filters. They are effective in the control of line-to-line as well as line-to- ground RFI interference. The K series RFI filters are particularly suited in applications where pulsed, continuous and/or intermittent RFI interference is present. The EK models meet the very low leakage current requirements of SEV, VDE portable equipment, and (120 Volt) UL544 nonpatient medical equipment.

The EP/VP series of RFI filters are designed to reduce conducted noise to acceptable limits for equipment that must comply with the requirements of CISPR in Europe and the FCC specifications in the USA.

Corcom R Series dual T section RFI power line filters provide premium performance at moderate cost. They are well suited for low impedance loads where noisy RFI environments are present. They control pulsed, continuous and/or intermittent interference, insuring protection of your equipment from power line noise in addition to protecting the line from equipment noise. The R series dual T type provides low leakage current without deterioration of insertion loss characteristics and at a competitive cost. The ER models meet the very low leakage current requirements of SEV, VDE portable equipment, and (120 Volt) UL544 nonpatient medical equipment.

V and W series power line RFI filters are used to suppress conducted interference and noise in high-noise industrial environments

The M series power entry modules offer the most choices of power entry components and filtering options to fit a specific need. The fully configured M series expands the options of a manufacturer whose products are marketed worldwide. One component, fully assembled and tested, provides the capability of interfacing a multi-voltage power supply to any common voltage or fusing scheme in the world, without modification. The IEC connector provides an internationally accepted power entry termination, which can be used with a variety of line cords. The selectable fuseholder allows use of single or dual European fuses, or a single North American fuse. The optional DPST on/off switch breaks both sides of the line and is labeled with the international I/O markings. The optional voltage selector provides a convenient means to change transformer primary connection, and it is available in both 2-voltage and 4-voltage configurations. The series is available with four filter circuits to meet a variety of applications, and convenient connections are provided on unfiltered models to allow wiring of a separate RFI filter. The M series is a family of components offering maximum flexibility and cost-effectiveness in the selection of primary power components. Wiring to the modules is accomplished via .110” terminals for labor savings and convenience. Four filter circuits provide a choice of attenuation tailored to specific categories o

SK series 20, 30 and 40 amp high performance K series RFI power line filters, meets the FCC specifications in the USA and CISPR specifications in Europe. The SK series filters offer significantly higher performance than the K series, which makes this series particularly suited for equipment with high line-to-ground as well as line-to-line conducted emissions. The ESK models meet the very low leakage current requirements of SEV, VDE portable equipment and (120 Volt) UL544 nonpatient medical equipment. Models ESK6C and VSK6C additionally incorporate a separate ground-circuit inductor to isolate the equipment chassis from power line ground at RF frequencies.

EDP EOP Series PC Board Mountable RFI Filters for General Purpose Applications have low leakage current for European safety requirements.

B series are general purpose common-mode filters effectively providing RFI control of line-to-ground noise in a small size at low cost. These filters are designed to meet a wide variety of electronic and electrical applications and are available in a broad selection of current ratings and termination styles. The EB models meet the very low leakage current requirements of SEV, VDE portable equipment, and (120 Volt) UL544 nonpatient medical equipment.