ANALOG Manuals

The ADF7020 is a high performance, ISM band, FSK/ASK transceiver IC operating in the frequency range of 431 MHz to 478 MHz and 862 MHz to 956 MHz.

ADF7902 is a low power UHF receiver IC that supports 2 kbps data rate and 34.8 kHz frequency deviation. It operates at 5V and consumes 18.5mA of current.

The ADF7012 is a low power FSK/GFSK/OOK/GOOK/ASK UHF transmitter designed for short-range devices (SRDs). The output power, output channels, deviation frequency, and modulation type are programmable by using four, 32-bit registers.

The ADF7901 is a low power OOK/FSK UHF transmitter designed for use in RF remote control devices. It is capable of frequency shift keying (FSK) modulation on eight different channels, selectable by three external control lines. OOK modulation is performed by modulating the PA control line.

AD9357 is a 2x2 MIMO RF transceiver operating in the 3.3GHz to 3.8GHz band with a bandwidth of 3.5MHz to 10MHz. The transceiver integrates 12-bit ADCs and DACs, offers superior receiver sensitivity and high linearity and spectral purity.

The AD9356 is a 2x2 MIMO RF transceiver that supports WiMAX/BWA/WiBRO/LTE bands, with bandwidth of 3.5-10MHz, superior receiver sensitivity with NF<3.2dB, highly linear and spectrally pure transmitter Tx EVM:-40dB, SNR:>130dB/Hz.

The AD9354 is a radio frequency (RF) transceiver with a single integrated ADC and DAC, supporting the IEEE 802.16 WiMAX/WiBro standard. The bandwidth is 3.5 MHz < BW < 10 MHz, the receiver sensitivity is high, the noise figure is less than 3.5 dB, and it supports manual Rx gain and autonomous AGC mode. The transmitter has high linearity and spectral purity, the output power control range is 58 dB, and the resolution is 0.25 dB. It integrates a fractional-N synthesizer, the LO step size is 10 Hz, the LO integrated phase noise is less than 0.4°rms, and the automatic frequency correction accuracy is less than 0.012 ppm. It supports the industry-standard JESD-207 digital interface.

The AD9355 is a dual-receiver, single-transmitter radio frequency (RF) transceiver that supports the IEEE 802.16 WiMAX/WiBro standard. It has a bandwidth of 3.5 MHz to 10 MHz, a receiver sensitivity of up to NF<3.5 dB, and a transmit power control range of 58 dB with a resolution of 0.25 dB.

The AD9353 is a fully integrated WiMAX RF MxFE transceiver that integrates ADCs and DACs, operates in the 3.3 to 3.8 GHz band, and has a bandwidth of 3.5 to 20 MHz. The AD9353 has a low noise figure of 3.2 dB and a highly linear and spectrally pure transmitter.

The AD9352 is a fully integrated RF transceiver with integrated ADCs and DACs, designed for WiMAX/WiBro applications. It offers superior receiver sensitivity and highly linear transmitter characteristics, with features such as automatic gain control and transmit power control.

The AD9837 is a low power, programmable waveform generator capable of producing sine, triangular, and square wave outputs.

The AD9838 is a low power DDS device capable of producing high performance sine and triangular outputs. It also has an on-board comparator that allows a square wave to be produced for clock generation. Consuming only 11 mW of power

The AD9912 is a 1 GSPS direct digital synthesizer with integrated 14-bit DAC that provides high performance, low jitter, and compact passive LO frequency synthesis for a variety of applications.

The AD9913 Rev. A is a low power 250 MSPS 10-bit DAC 1.8 V CMOS Direct Digital Synthesizer.

1 GSPS, 14-Bit, 3.3 V CMOS Direct Digital Synthesizer Data Sheet AD9910 Rev. D is a frequency synthesizer produced by American Analog Devices company. Its main features are the internal clock speed up to 1 GSPS, support for 14-bit DAC, frequency resolution up to 0.23 Hz, phase noise as low as -125 dBc/Hz @ 1 kHz offset (400 MHz carrier), and excellent dynamic performance with bandwidth SFDR up to >80 dB.