TEXAS Manuals (Others)

The MAX202 device consists of two line drivers, two line receivers, and a dual charge-pump circuit with ±15-kV ESD protection pin to pin (serial-port connection pins, including GND). The device meets the requirements of TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 5-V supply. The device operates at data signaling rates up to 120 kbit/s and a maximum of 30-V/µs driver output slew rate.

File format: PDF Size:331 KB

This datasheet is about LM224, LM324, LM2902 four operational amplifiers, these operational amplifiers have 2kV ESD protection, wide supply voltage range, low supply current, ground included common mode input voltage range, low input bias current and offset voltage, etc.

File format: PDF Size:606 KB

TVP70025I is a triple 10-bit, 90-MSPS video and graphics digitizer with features such as horizontal PLL, analog channels, pixel clock generation, automatic video clamp, and digitizing channels.

File format: PDF Size:603 KB

The TVP7002 is a triple 8-/10-bit 165-/110-MSPS video and graphics digitizer with horizontal PLL from Texas Instruments.

File format: PDF Size:560 KB

TVP7002 is a triple channel 8-/10-bit 165-/110-MSPS video and graphics digitizer with a horizontal PLL. It features adjustable horizontal PLL loop bandwidth, support for RGB/YCbCr 4:4:4 and YCbCr 4:2:2 output modes, and is suitable for component video standards such as 480i, 576i, 480p, 576p, 720p, 1080i, and 1080p.

File format: PDF Size:560 KB

TVP7001 is a complete solution for digitizing video and graphic signals in RGB or YPbPr color spaces. The device supports pixel rates up to 165 MHz.

File format: PDF Size:382 KB

TVP7001 is a complete solution for digitizing video and graphic signals in RGB or YPbPr color spaces. It can be used for PC graphics digitizing up to the VESA standard of UXGA (1600 × 1200) resolution at 60 Hz screen refresh rate, and in video environments for the digitizing of digital TV formats, including HDTV up to 1080p.

File format: PDF Size:382 KB

File format: PDF Size:362 KB

This document is a TI TVP7000 datasheet. It is a video and graphics digitizer that supports RGB and YPbPr color spaces and supports the acquisition of images with pixel rates up to 150MHz.

File format: PDF Size:362 KB

This document is the data manual for TVP6000C NTSC/PAL Digital Video Encoder, which describes the technical specifications and features of the product.

File format: PDF Size:248 KB

This document is the TVP6000C data manual, which introduces the function and features of the product

File format: PDF Size:248 KB

TVP5154 is a low-power 4-channel PAL/NTSC/SECAM video decoder with independent scalers and fast lock.

File format: PDF Size:827 KB

This datasheet introduces the features of TVP5154 4-channel low-power PAL/NTSC/SECAM video decoder, supports ITU-R BT.601 standard sampling format, and provides up to 2x oversampled VBI data decoding, and also has a 2x3-H delay compensation filter, which can be used for video signals. Noise reduction processing.

File format: PDF Size:827 KB

This document describes a product called SLOS414E, which is a high-gain, frequency-compensated operational amplifier suitable for automotive applications. The product features low power consumption, ESD protection, low input bias and offset parameters, etc.

File format: PDF Size:208 KB

File format: PDF Size:304 KB

ULN2003AI is a high-voltage, high-current Darlington transistor array product from TI. This device consists of seven npn Darlington pairs that feature high-voltage outputs with common-cathode clamp diodes for switching inductive loads. The collector-current rating of a single Darlington pair is 500 mA. The Darlington pairs can be paralleled for higher current capability. It is suitable for relay drivers, hammer drivers, lamp drivers, display drivers (LED and gas discharge), line drivers and logic buffers.

File format: PDF Size:304 KB

This document is about ULN2803A technical data, including 500-mA rated collector current (single output), high-voltage outputs, output clamp diodes, inputs compatible with various types of logic, relay driver applications, and other information

File format: PDF Size:247 KB

The ULN2001A is obsolete and is no longer supplied. This is a document about ULN2001A, ULN2002A, ULN2003A, ULN2004A, ULQ2003A and ULQ2004A. They are high-voltage, high-current Darlington transistor arrays. Each array consists of seven npn Darlington pairs that feature high-voltage outputs with common-cathode clamp diodes for switching inductive loads. The collector-current rating of a single Darlington pair is 500 mA. The Darlington pairs can be paralleled for higher current capability. Applications include relay drivers, hammer drivers, lamp drivers, display drivers (LED and gas discharge), line drivers, and logic buffers.

File format: PDF Size:514 KB

The ULN2001A is obsolete and is no longer supplied.

File format: PDF Size:663 KB

The document describes the features and characteristics of the ULN2001A series, a high-voltage and high-current Darlington transistor array. Each array consists of seven npn Darlington pairs with high-voltage outputs and common-cathode clamp diodes for switching inductive loads. The collector-current rating of a single Darlington pair is 500mA, and they can be paralleled for higher current capability. Applications include relay drivers, hammer drivers, lamp drivers, display drivers (LED and gas discharge), line drivers, and logic buffers.

File format: PDF Size:663 KB