ST Manuals

The UA748 is a general purpose operational amplifier with features such as low offset and temperature drift, large common-mode and differential voltage ranges, low power consumption, and short-circuit protection. It can be used as a comparator and amplifier.

File format: PDF Size:156 KB

The TS912 is a single/dual supply operation rail-to-rail CMOS dual operational amplifier with extremely low input bias current, low input offset voltage, low supply current and latch-up immunity

File format: PDF Size:216 KB

This document describes the features and characteristics of the precision low power CMOS quad operational amplifiers TS27M4C, TS27M4I, and TS27M4M, released in September 2008 Rev 2.

File format: PDF Size:159 KB

TS27M2, TS27M2A, TS27M2B Low-power CMOS dual operational amplifiers feature a wide supply voltage range (3 to 16 V), ultra-low consumption (150 µA/op), output voltage swing to ground, excellent phase margin on capacitive load, gain bandwidth product of 1 MHz typical, and Vio down to 2 mV max. (B version)

File format: PDF Size:200 KB

The TS27L4 series are low-cost, low-power quad operational amplifiers designed to operate with single or dual supplies. These operational amplifiers use the ST silicon gate CMOS process allowing an excellent consumption-speed ratio. These series are ideally suited for low consumption applications. Three power consumptions are available enabling the best consumption-speed ratio: ICC = 10 µA/amp: TS27L4 (very low power), ICC = 150 µA/amp: TS27M4 (low power), ICC = 1 mA/amp: TS274 (standard). These CMOS amplifiers offer very high input impedance and extremely low input currents. The major advantage versus JFET devices is the very low input current drift with temperature (see Figure 4).

File format: PDF Size:212 KB

File format: PDF Size:0 KB

TS272 series of low power dual operational amplifiers

File format: PDF Size:203 KB

The TS271 is a low cost, low power single operational amplifier designed to operate with single or dual supplies. It offers very high input impedance and extremely low input currents.

File format: PDF Size:642 KB

The TL084 is a high performance, high speed, low power JFET quad operational amplifier with a wide common-mode voltage range (up to VCC +), low input bias and offset current, output short-circuit protection, high input impedance JFET input stage, internal frequency compensation, latch up free operation and high slew rate: 16 V/µs (typical).

File format: PDF Size:350 KB

The TL082 is a dual operational amplifier from STMicroelectronics. It features high output bandwidth, low input bias current and low output voltage drift.

File format: PDF Size:331 KB

The TL081, TL081A, and TL081B are high-speed JFET input single operational amplifiers incorporating well matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. The devices feature high slew rates, low input bias and offset currents, and low offset voltage temperature coefficient.

File format: PDF Size:337 KB

The TL072, TL072A and TL072B are high speed JFET input dual operational amplifiers incorporating well matched, high voltage JFET and bipolar transistors in a monolithic integrated circuit.

File format: PDF Size:319 KB

This document provides information about a product in full production. The product is a low noise JFET quad operational amplifier with wide common-mode and differential voltage range, low input bias and offset current, low noise, low harmonic distortion, and other features.

File format: PDF Size:321 KB

The TL071 is a high-performance, low-noise, high-input-impedance single-voltage-output operational amplifier. This operational amplifier uses well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. The device features high gain bandwidth, low input bias current, low input offset voltage, and good frequency compensation characteristics and thermal stability.

File format: PDF Size:307 KB

The TL064 is a low-power JFET quad operational amplifier with features including low power consumption, wide common-mode and differential voltage ranges, low input bias and offset currents, output short-circuit protection, high input impedance, and internal frequency compensation.

File format: PDF Size:252 KB

The TL062, TL062A and TL062B are high-speed JFET input single operational amplifiers. Each of these JFET input operational amplifiers incorporates well matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. The devices feature high slew rates, low input bias and offset currents, and a low offset voltage temperature coefficient.

File format: PDF Size:618 KB

TL061 is a low-power JFET single operational amplifier with features such as low power consumption, wide common-mode and differential voltage ranges, low input bias and offset currents, output short-circuit protection, high input impedance JFET input stage, internal frequency compensation, latch-up free operation, and high slew rate.

File format: PDF Size:327 KB

MC4558 is a high performance monolithic dual operational amplifier produced by ST. It has internally compensated, short-circuit protection, gain and phase match.

File format: PDF Size:459 KB

The MC3x174 series is a quad bipolar operational amplifier offering both low consumption and good speed. It allows single supply operation from +4V to +44V and has a wide input common mode voltage range including VCC-. The low-level output voltage is close to VCC-.

File format: PDF Size:84 KB

The MC3x172 series are dual bipolar operational amplifiers offering both low consumption (200 µA/Amp) and good speed (2.1 MHz, 2 V/µs). Moreover, the input common mode range extends down to the lower supply rail, allowing single supply operation from +4 V to +44 V.

File format: PDF Size:138 KB