Industrial

This document is the datasheet of STEVAL-IPR002V1. It introduces the features of the product, including dual communication interfaces (RF and I2C) of M24LR64 EEPROM, temperature, motion (MEMS), humidity and light (photo diode) parameters recording, two operation modes (RFID mode and I2C mode), 20mm x 40mm inductive antenna, and Android NFC application DatalogV3

The Keil starter kit for STM32F4 series microcontrollers (STM32F407IG MCU) is a complete, cost-effective solution for starting application development and evaluating the STMicroelectronics STM32F4 series ARM Cortex™-M4 processor-based microcontrollers. It provides all the hardware and software you need to start developing applications for the STM32 ARM core-based families of microcontrollers.

The IAR KickStart Kit™ is a complete, cost-effective solution for starting application development and evaluating the STMicroelectronics STM32F4-series ARM core-based microcontrollers.

This document describes the features and characteristics of the STEVAL-IHT007V1 extension board. It can directly drive 110/220VAC loads, isolate the high voltage side using opto-transistors, synchronize Triac/AC switch pulses with AC mains using zero voltage switching, and provide full wave on/off control. It is designed for small AC loads up to 500W used in home appliances and home and building automation.

This is a 75W SMPS power adapter that supports 90-264Vac input voltage, frequency 45-65Hz, output voltage 19V@4A, and meets the latest Energy Star® standards.

The STEVAL-ISA084V1 is a demonstration board for the ST1S40, a 800 kHz fixed-frequency PWM synchronous step-down converter. It features a 4A peak output current, 800 kHz switching frequency, and enable on/off function.

This datasheet introduces STEVAL-IHM036V1 motor control board based on 600V, 3A small low-loss intelligent molded module (SLLIMM™) STGIPN3H60 and STM32F100C6T6B MCU, which achieves fast and accurate conditioning of the current feedback, rendering it capable of meeting the typical requirements for field-oriented control (FOC).

Describe the features of the STEVAL-IFP019V1 demonstration board, including output current, shorted load protections, junction overtemperature protection, case overtemperature protection, thermal case shutdown and non-simultaneous restart.

This document provides detailed information about the EVAL6470PD motor driver, including voltage range, phase current, SPI connector, SW input, FLAG and BUSY LED indicators, adjustable supply voltage compensation, and high thermal performance

This datasheet describes the features of the STEVAL-IMR002V1 2 kW/100 V RF demonstration board based on the STAC4932B, including output power, supply voltage, frequency, power gain, efficiency, RoHS compliance, etc.

STEVAL-ISA091V1 is a step-down switching power supply based on the L7980 switching regulator. It features a 2A DC output current, a 4.5V to 28V input voltage range, an adjustable output voltage from 0.6V, a programmable switching frequency up to 1MHz, internal soft-start and enable functions, low dropout operation with 100% duty cycle, and overcurrent and thermal protection.

This data brief introduces the features of the STEVAL-ISA093V1, a 3A step-down switching power supply demonstration board based on STMicroelectronics’ L7981 switching regulator in a QFN package.

This datasheet provides detailed information on the STEVAL-ISA092V1, including features, specifications, applications, etc.

This data sheet introduces STEVAL-ISA094V1 3 A step-down switching power supply demonstration board features, including output current, input voltage, output voltage, switching frequency, etc.