ST Manuals

The VN808-32-E is an eight-channel high side driver with VCC/2 compatible input, junction overtemperature protection, case overtemperature protection, current limitation, shorted load protection, undervoltage shut-down, protection against loss of ground, very low stand-by current and compliance to 61000-4-4 IEC test up to 4 kV.

This is a datasheet for VNI4140K Quad high-side smart power solid-state relay. The relay has an output current of 0.7 A per channel, shorted load protections, and temperature protections.

The L6388E is a high-voltage high and low side driver with features such as high-voltage rail, dV/dt immunity, and high driver current capability.

The L6387E is a high-voltage high and low side driver from ST company, with 600V voltage rail, dV/dt immunity ±50V/nsec, 400mA source, 650mA sink, 50/30nsec rise/fall time, CMOS/TTL Schmitt trigger inputs, internal bootstrap diode, outputs in phase with inputs, interlocking function and other features.

The L6386E is a high-voltage high and low side driver with features such as high voltage rail, dV/dt immunity, driver current capability, fast switching times, CMOS/TTL inputs, and under-voltage lockout.

The TDE1708DFT intelligent power switch has a low side or high side switch configuration, a supply voltage range of 6V to 48V, overload and short circuit protections, internal voltage clamping, supply and output reversal protection, thermal shutdown, GND and VS open wire protection, adjustable delay at switch on, indicator status LED driver, +5V regulated aux. voltage, and high burst immunity.

The L6375S is a monolithic intelligent power switch with a high-side driver function. It has a 0.5A output current, a supply voltage range of 8V to 35V, internal current limiting and thermal shutdown, open ground protection, internal negative voltage clamping for fast demagnetization, differential inputs with a large common mode range and threshold hysteresis, undervoltage lockout with hysteresis, open load detection, two diagnostic outputs, an output status LED driver, non-dissipative short-circuit protection, immunity against burst transient (IEC 61000-4-4), and ESD protection.

The L9524C is a control IC for up to six glow plugs of diesel engines. The glow plugs are switched by up to four external PWM-controlled N-channel Power MOSFETs or a single relay in high-side configuration. Supply voltage, battery voltage, junction temperature, switches, currents through the glow plugs, and charge pump voltage are monitored. A two-wire interface is used to communicate with the diesel engine management system.

STUSB03E is a USB transceiver produced by ST company. It supports USB 2.0 protocol with a speed of up to 12Mbps. It supports low power consumption and low voltage power supply, and is suitable for PDAs, MP3 players and mobile phones.

The device is specifically designed to provide all the necessary features to implement a single phase energy meter without any other active component.

The L6375D is a monolithic intelligent power switch in BCDmultipower technology, for driving inductive or resistive loads with controlled output voltage slew rate and short-circuit protection. It features a 0.5 A output current, 8 V to 35 V supply voltage range, internal current limiting, thermal shutdown, open ground protection, internal negative voltage clamping for fast demagnetization, differential inputs with large common mode range and threshold hysteresis, undervoltage lockout with hysteresis, open load detection, two diagnostic outputs, output status LED driver, non-dissipative short-circuit protection, immunity against burst transient (IEC 61000-4-4), and ESD protection (human body model ±2 kV).

This document introduces the features and characteristics of ST's L6384E high-voltage half bridge driver product, including high voltage rail range, driver current capability, switching time, logic input type, dead time setting, under voltage lockout, integrated bootstrap diode, and capacitor clamping.

The L6385E is an STMicroelectronics high-voltage high and low side driver, featuring high voltage rail up to 600V, dv/dt immunity ±50V/nsec, switching times 50/30 ns rise/fall, 1nF load, CMOS/TTL Schmitt trigger inputs, under voltage lock out and outputs in phase with inputs.

L6360 IO-Link communication master transceiver IC Datasheet - production data

The VNI4140K-32 is a quad high side smart power solid state relay with features such as 1A output current per channel, shorted load protections, overtemperature protection, etc.