ANALOG Manuals

This document describes the features and characteristics of the ADM8696/ADM8697 microprocessor supervisory circuits, including adjustable low voltage monitor, power OK/reset time delay, watchdog timer, low switch on resistance, automatic battery backup switching, etc.

AD9834 is a 20mW power, 2.3V to 5.5V power supply, 50MHz complete DDS chip. It has Narrow-band SFDR>72dB, 2.3V to 5.5V power supply, 50MHz reference clock, 0MHz to 25MHz output, sine output/triangular output, on-board comparator, 3-wire SPI® interface, extended temperature range (-40°C to +105°C), power-down option, 20mW power consumption, 3V, 20-Lead TSSOP package and other features.

This datasheet provides detailed information on the AD7927, including features, specifications, pins, and package.

The AD5932 is a waveform generator from AD company. It supports frequency scanning and can generate analog or digital frequency stepped waveforms. The device uses embedded digital processing technology to achieve enhanced frequency control. Since the frequency is pre-programmed, continuous write cycles are eliminated, thereby freeing up valuable DSP/microcontroller resources. Waveforms start from a known phase and are incremented phase-continuously, which allows phase shifts to be easily determined. The AD5932 consumes only 6.7 mA of power and provides a convenient low-power solution for waveform generation. No external components are required, the output frequency can reach 25MHz, and it has burst and listen capability and a pre-programmed frequency profile.

AD9833 is a low power 20mW 2.3V to 5.5V programmable waveform generator.

AD2S1205 is a 12-bit R/D converter with reference oscillator

The OP270 is a high performance, monolithic, dual operational amplifier with exceptionally low voltage noise, 5 nV/÷Hz max at 1 kHz. It offers comparable performance to ADI’s industry standard OP27. The OP270 features an input offset voltage below 75 mV and an offset drift under 1 mV/∞C, guaranteed over the full military tem- perature range. Open-loop gain of the OP270 is over 1,500,000 into a 10 kW load, ensuring excellent gain accuracy and linearity.

The AD5441 is a 12-bit multiplying digital-to-analog converter with serial input. It features excellent analog performance and is ideal for applications where PC board space is limited.

AD8510/AD8512/AD8513 are low noise, low input bias current, wide bandwidth JFET operational amplifiers produced by Analog Devices

AD7357 is a dual 14-bit SAR ADC with a maximum conversion rate of 4.2 MSPS and a 2.5 V supply voltage. It is packaged in a 16-lead TSSOP.

The AD5930 is a programmable frequency sweep and output burst waveform generator. It features a programmable frequency profile, no external components necessary, output frequency up to 25 MHz, burst and listen capability, preprogrammable frequency profile minimizes number of DSP/µcontroller writes, sinusoidal/triangular/square wave outputs, automatic or single pin control of frequency stepping, waveform starts at known phase, increments at 0° phase or phase continuously, power-down mode: 20 µA, power supply: 2.3 V to 5.5 V, automotive temperature range: −40°C to +125°C, 20-lead pb-free TSSOP. It is suitable for frequency sweeping/radar, network/impedance measurements, incremental frequency stimulus, sensory applications, proximity and motion, BFSK frequency bursting/pulse trains, etc.

The AD598 is a complete, monolithic Linear Variable Differential Transformer (LVDT) signal conditioning subsystem. It is used in conjunction with LVDTs to convert transducer mechanical position to a unipolar or bipolar dc voltage with a high degree of accuracy and repeatability. All circuit functions are included on the chip. With the addition of a few external passive components to set frequency and gain, the AD598 converts the raw LVDT secondary output to a scaled dc signal. The device can also be used with RVDT transducers.

This document describes the features and characteristics of the ADV7174/ADV7179 chip scale PAL/NTSC video encoder, including ITU-R1 BT601/BT656 YCrCb to PAL/NTSC video encoder, high quality 10-bit video DACs, advanced power management features, etc.