Update: 28 September, 2023
The stacked combination structure can be arbitrarily combined into a multi-beam interception system. The infrared wall is an efficient and reliable single-beam academic structure system. The intuitive LED/voltage indicates the alignment with the red alarm LED off. The detection distance is wide and the angle is adjustable. The outdoor 8 meters horizontal direction is 200 degrees vertical direction 10 degrees anti-disassembly protection normally closed contact ALC automatic gain control circuit surface shell can withstand high-intensity impact and prevent destruction. The unique optical system can reduce environmental stray light interference. It can penetrate dense fog or multiple transparent glass vertical barriers without being affected by user opening and closing windows. Optional accessories EX408 expansion module AH2 heating module installation instructions product features product features performance indicators performance indicators Model DS418 power supply 10-15VDC power consumption transmitter <10mA receiver <20mA application environment -25+55 RH35 90% -0+55 with attachment AH2-40+60 RH35 90% outdoor: 27 feet 8 meters control measurement mode infrared pulse beam status indication transmitter: red LED power indication receiver: red LED alarm indication alarm output C-type relay NC/NO anti-disassembly output NC optical system single beam optical axis horizontal adjustment 200 degrees optical axis vertical adjustment 20 degrees packaging size (HWL) 63 125 115mm product design is subject to change without notice product appearance diagram (µ¥Î»:mm) product appearance diagram (µ¥Î»:mm) installation position installation position diagram diagram single installation diagram recommended installation height is about 15cm multiple installation diagrams the following figure is an example of window installation installation instructions P/N: 4998134015B wiring diagram wiring diagram single detector wiring diagram multiple detector wiring diagram to control panel To Control Panel transmitter Transmitter receiver Receiver power supply Power anti-disassembly Tamper power supply Power anti-disassembly Tamper EOL to control panel To Control Panel power supply Power anti-disassembly Tamper transmitter Transmitter receiver Receiver EOL Figure 3 Figure 2 Figure 1 installation Mount the connected mounting backplate to the wall at the installation location using the screws and triangular plate provided with the accessory. Connect the wires through the inlet and outlet as shown in the figure. The appearance of the product is exquisite and the structure is compact. Please install it according to the provided methods to achieve the best effect. Figure 3 Figure 2 Figure 1 Two installation steps The wire heads left at the wiring end should be connected according to the figure without leaving them too long and press them under the film. Install the bottom shell with the backplate fixed by screws at the transmitter end and fix it with screws. Install the light reduction mask and adjust the optical horizontal and vertical angles of the transmitter and receiver until the alarm indicator light is off. Use a multimeter to measure the voltage of MJ1 and MJ2 ends. The voltage should be above 0.2V (2.5V gear) from top to bottom. Install the top cover until it is in place. Adjust the screw in the azimuth direction of the adjusting frame of the elevation angle. Light reduction plate triangular plate outlet hole power alarm cable inlet wire down to the next level power alarm cable power alarm cable stripping 10mm One installation step Figure 7 Figure Figure 6 Figure 5 Figure 4 From top to bottom, install the bottom shell with the threaded wire in the following order and fix it with screws at A. Press it tightly inside and push it up and tighten it with screws B. Install the shell and top cover from bottom to top, paying attention to the groove of the shell should be aligned with the bottom shell.
File format: PDF
Size: -
MD5 Checksum: 117420B39D870F6850323D448FDB50A3
Publication date: 11 February, 2012
Downloads: -
PDF Link: DS418 installation Manual PDF