ATC Manuals

Anachip's AM24LC08 is a non-volatile, 8192-bit serial EEPROM that conforms to all I2C 2 wire protocol specifications. The AM24LC08 communication protocol uses CLOCK(SCL) and DATA I/O(SDA) lines to synchronously clock data between the master (for example a microcomputer)and the slave EEPROM devices(s) .In addition, the bus structure allows for a maximum of 8 devices to be connected to the bus. The AM24LC08 has a 16-byte page write mode to minimize the total write time per word. The AM24LC08 has a self-timed write cycle (including auto-erase). The AM24LC08 has a 40-year data retention period, a minimum of 1M write/erase cycles per word, unlimited read cycles, ESD protection and low standby current. The AM24LC08 is available in PDIP-8L and SOP-8L packages.

The document describes a product called 24LC02. The product is an ATC circuit with pins such as VCC, WP, SCL, SDA, A0, A1, A2, and VSS. It is a memory chip with specific features and characteristics.

ATS477 is a single-phase hall effect latch produced by Anachip Company. It integrates hall sensor and output drivers and is used for the electronic commutation of brushless DC motor. The device includes a chip-on Hall voltage generator for magnetic sensing, an error amplifier that amplifies the Hall voltage, a comparator that is to provide switching hysteresis for noise rejection, the bi-direction drivers for sinking and driving large current load, and the frequency generator (FG) that provides a signal proportional to rotation speed. Internal bandgap regulator is used to provide temperature compensated bias for internal circuits and allows a wide operating supply voltage range. Built-in protection circuits can prevent overvoltage, overcurrent and overheating.

ATS177 is an integrated Hall effect latched sensor designed for electronic commutation of brush-less DC motor applications. The device includes an on-chip Hall voltage generator for magnetic sensing, a comparator that amplifies the Hall voltage, and a schmitt trigger to provide switching hysteresis for noise rejection, and open-collector output.

ATC-2000 is a communication interface converter that is used to complete data conversion between TCP/IP and RS-232/422/485, and it is widely used in industrial control, access control, attendance system, meal system, POS system, building automation system, power system, monitoring and data acquisition system, self-service banking system, etc.