This page provides manuals, user guides, handbooks, instructions, specification, instruction, maintenance manual for ST Anti-Theft Devices, Electronic Original, ...
The document describes the features and characteristics of the 74LCX245 low voltage CMOS octal bus transceiver. It has 5V tolerant inputs and outputs, and is suitable for low power and high speed 3.3V applications. This product is intended for two-way asynchronous communication between data buses, with the direction of data transmission determined by the DIR input. The enable input G can be used to disable the device, effectively isolating the buses. All inputs and outputs are equipped with protection circuits against static discharge, providing 2KV ESD immunity and transient excess voltage protection. All floating bus terminals during the High Z state must be held HIGH or LOW.
HCF4541B is a monolithic integrated circuit produced by Honeywell Corporation. It is mainly used as a timer and uses metal oxide semiconductor technology. It has two packaging forms: DIP and SOP. The device consists of a 16-stage binary counter, an oscillator controlled by two external resistors and a capacitor, an output control logic and an automatic power-on reset circuit. The counter can change at the positive edge clock transition and can be cleared by the MASTER RESET input. The output of this timer is the Q or Q output from the 8th, 13th, or 16th counter stage. The choice of the stage depends on the time.
HCF4030B is a monolithic integrated circuit fabricated in Metal Oxide Semiconductor technology available in DIP and SOP packages. It consists of four indipendent exclusive-OR gates integrated on a single monolithic silicon chip. Each exclusive-OR gate consists of four n-channel and four p-channel enhancement-type transistors. All inputs and outputs are protected against electrostatic effects.
The HCF4014B is a monolithic integrated circuit fabricated in Metal Oxide Semiconductor technology. It is an 8-stage parallel or serial input/serial output register with master-slave flip-flops and output buffering. It operates at medium speed and is fully static. The device meets all requirements of JEDEC JESD13B standard.
The M22100 is a 4x4 crosspoint switch with built-in control latches and large analog signal capability. It can transmit signals up to 10 MHz and has matched switch characteristics, high linearity, and standard COS/MOS noise immunity.
M74HCU04 is a high speed CMOS Hex Invertor (Single State) fabricated with silicon gate C2MOS technology. As internal circuit is composed of a single stage inverter, it can be used in crystal oscillator. All inputs are equipped with protection circuits against static discharge and transient excess voltage.
M74HCT74 is a CMOS DUAL D TYPE FLIP FLOP WITH CLEAR, which has the characteristics of high speed, low power consumption, and compatibility with TTL. It is suitable for direct interface with HSC2MOS systems, TTL and NMOS components.
This document describes the features of the 74HCT540 model, including high-speed transmission, low power dissipation, and compatibility with TTL outputs.
The M74HCT373 is a high-speed CMOS octal latch with 3-state outputs. It is fabricated with sub-micron silicon gate C2MOS technology and features high speed, low power dissipation, and compatibility with TTL outputs.
M74HCT367 is a high-performance CMOS hex buffer with 3-state outputs. This device consists of six buffers, four buffers are controlled by an enable input (G1) and the other two buffers are controlled by the other enable input (G2); the outputs of each buffer group are enabled when G1 and/or G2 inputs are held low, and when held high, these outputs are disabled in a high-impedance state. All inputs are equipped with protection circuits against static discharge and transient excess voltage.
