Apple Manuals

This document describes how to replace the ATA hard drive in a Power Mac G4 Cube 073-0541 Rev. C computer.

This document is about Power Mac G4 Cube 073-0545 computer enclosure replacement instructions

This document describes how to turn off virtual memory when using SoftRAID 2.1.5 software for optimal stability and performance.

This booklet contains information about how to maintain, repair, and reinstall some software on an optional 36 GB hard disk, how to install or replace internal hard disk drives, and what kinds of devices work with the optional SCSI card installed in some models.

This document describes the basics of setting up and using a computer, including connecting a monitor, keyboard, and mouse, and turning on the computer for the first time. It also provides information on connecting and installing other devices in separate chapters.

This document describes how to use PC Compatibility Card software to access PC environment, including how to connect monitors, connect other devices.

This is a manual on how to set up and use a Mac computer.

This document provides instructions on how to set up a Power Macintosh computer, including how to set the voltage switch, connect the display and keyboard, and install the operating system.

This document describes the equipment needed to set up and use a computer, including a monitor, keyboard, and mouse. It also provides guidelines for connecting other devices and offers suggestions for adjusting the work environment.

This chapter describes how to install the PC Serial and Parallel Card in a Power Macintosh 4400 or a Power Macintosh 7220. After you install the PC Serial and Parallel Card hardware, go to Chapter 6, “Updating Your PC Compatibility Card Software.” Then turn to Chapter 7 to learn more about connecting PC-compatible equipment to your PC Serial and Parallel Card.

This chapter describes how to install the PC Compatibility Card hardware in a Power Macintosh 4400 computer—or a Power Macintosh 7220, available in some countries. IMPORTANT If you will be installing a PC Serial and Parallel Card with your PC Compatibility Card, it’s easiest to install both cards at the same time. The PC Serial and Parallel Card has standard PC ports that allow you to use several kinds of PC-compatible peripherals from the Windows or DOS environment (not from the Mac OS environment). Instructions in this chapter indicate when to see your PC Serial and Parallel Card manual for installation information. After you install the PC Compatibility hardware, go to Chapter 5, “Connecting Monitors and Other Equipment.” If you want to install additional memory in your card, go to Appendix B, “Adding Memory to Your PC Compatibility Card.” Then turn to Chapters 6 through 9 to learn more about installing and using PC software. WARNING Shipping your computer with a PC Compatibility Card installed may cause damage to the card. Your PC Compatibility Card should be shipped separately. (See Appendix A for instructions on how to remove the card.)

This chapter describes how to install the PC Serial and Parallel Card in a Power Macintosh 4400 or a Power Macintosh 7220. After you install the PC Serial and Parallel Card hardware, go to Chapter 6, “Updating Your PC Compatibility Card Software.” Then turn to Chapter 7 to learn more about connecting PC-compatible equipment to your PC Serial and Parallel Card.

Apple Power Macintosh 5260/120 Update: This model comes with a faster processor and greater minimum DRAM

This user's guide includes setup, troubleshooting, and important health-related information for Power Macintosh 9500 series computers

This chapter introduces how to set up a Macintosh computer and how to use the Macintosh computer's basic knowledge