KODENSHI Manuals

PC-17T1, PC-17T2, PC-17T4 are three photocouplers, which have small package size, low power consumption, high reliability and so on. These products are suitable for different voltage and current interconnection, such as sensor signal isolation, industrial control, communication equipment, etc.

KK74AC623 is a high-performance silicon-gate CMOS Octal 3-State Noninverting Bus Transceiver. It is pin-compatible with the LS/ALS623, HC/HCT623. The device inputs are compatible with standard CMOS outputs; with pullup resistors, they are compatible with LS/ALS outputs. The KK74AC623 is a 3-state noninverting transceiver that is used for 2-way communication between data buses. Two separate enables are available. The enable for bus A to B is active-high, the enable for bus B to A is active-low.

The document describes the features and characteristics of the SG-105 product.

This document describes the features and characteristics of a photo diode integrated circuit, including full CMOS seven channels, integrated high-speed photodiodes, and current-to-voltage transimpedance amplifiers. The product is optimized for DVD/CD applications with red laser diodes and CD applications with IR laser diodes. It has high PD sensitivity.

The PC-16T1 is a 4-pin single-channel photocoupler. Its features include small package size, minimum collector-emitter voltage of 35V, minimum current transfer ratio of 50% (at IF=1mA, VCE=5V), and electrical isolation voltage of AC2500Vrms. This photocoupler is suitable for applications such as interface between two circuits of different potential, programmable logic control, power supply, and computer terminals.

PC-17L1, PC-17L2, PC-17L4 Photocouplers, small package size, high isolation voltage, high reliability, widely used in various analog and digital circuits isolation, such as computer terminals, programmable logic controller, power supply, sensors, etc.

The KK74AC534 is an octal 3-state inverting D flip-flop with high-speed silicon-gate CMOS technology. The device outputs directly interface with CMOS, NMOS, and TTL. It operates in a voltage range of 2.0 to 6.0V and has a high noise immunity characteristic.

The document describes the features and characteristics of the SG-23FH product. This product has high performance and stability, and is suitable for various applications.

BMR-0201 System Reset IC is a system reset IC produced by NSHIKI. Its features are wide input voltage range, can work between -0.3V and 10V, low output voltage, as low as 0.4V, and low working current, only 2.5mA.

The KK74HC139A is a dual 1-of-4 Decoder/Demultiplexer consisting of two independent 1-of-4 decoders, each of which decodes a two-bit Address to one-of-four active-low outputs.

The document introduces an optic receiver module suitable for short-distance communication in indoor environments. The module has a wide operating temperature range and low voltage requirements.

The KK74AC574 is an eight-bit 3-state non-inverting D flip-flop, high-performance silicon-gate CMOS, output directly interfaces to CMOS, NMOS and TTL, operating voltage range 2.0 to 6.0V, low input current 1.0 uA; 0.1 uA @ 25°C, high noise immunity characteristic of CMOS devices, output source/sink 24 mA

VCSEL is a semiconductor microlaser diode that emits light in a cylindrical beam vertically from the surface of a fabricated wafer. It features an 850nm wavelength range, high data rate ≥ 2.5Gbps, high reliability, and low current and voltage.

The 74LV640 is a low-voltage Si-gate CMOS device and is pin and function compatible with 74HC/HCT640, providing six inverting buffers with Schmitt-trigger action.