Key facts
- Manuals
- 4
- Languages
- ZH
- Last added
- 2012-06-01
Featured EON manuals
Vimtek EON Script User Manual
This manual explains how to create and edit Script nodes in the EON environment, including the required field setup and basic VBScript/JavaScript syntax. It guides users through initializing scripts, processing events, and outputting new field values.
The document also describes advanced functions such as EventsProcessed for efficient execution and the Shutdown command for saving simulation state. Example code snippets for both VBScript and JScript are provided throughout. This manual is written in Chinese.
Covers: Script 節介紹 · 程式角本撰喜入門 · Script Properties · EventsProcessed · Shutdown
Latest EON manuals
EON EN29F002A EN29F002AN 2 Megabit (256K x 8-bit) Flash Memory
EN29F002A / EN29F002AN is a 5.0V ± 10% fast flash memory produced by Eon Silicon Solution, with read access time of 45ns, 55ns, 70ns and 90ns, and supports single sector and chip erase.
EON EN29F002 EN29F002N 2 Megabit (256K x 8-bit) Flash Memory
EN29F002 / EN29F002N is a 2-Megabit flash memory product with features including 5.0V voltage supply, multiple read access time options, sector architecture, high performance programming/erasing speed, and low power consumption.
EON EN27C512 512KBIT EPROM (64K x 8)
EN27C512 is a low-power 512Kbit, 5V-only one-time-programmable (OTP) read-only memory (EPROM). Organized into 64K words with 8 bits per word, it features QuikRiteTM single- address location programming, typically at 20µs per byte. Any byte can be accessed in less than 45ns, eliminating the need for WAIT states in high-performance microprocessor systems. The EN27C512 has separate Output Enable ( OE ) and Chip Enable ( CE) controls which eliminate bus contention issues.
Vimtek EON Script User Manual
User Manual 66 pages · 3.7 MB · ZHChinese user manual for Vimtek's EON Script, covering script creation, properties, and special functions.
Which document do I need?
User Manual
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in EON manuals
How do I start a script in EON?
You must add a new field to the Script node, set its type (e.g., outevent), and begin the script with an On_<fieldname> subroutine.
How can I shut down a simulation and save its state?
Use the Shutdown command, which executes a subroutine after the simulation ends and can store final field values for the next session.