Linear Technology Manuals - Page 27

Linear Technology manuals, page 27

• LINEAR dn413f handbook

  The LTC3530 monolithic synchronous converter can be used to design a wide input voltage range buck-boost converter. This converter can output 3.3V from an input voltage of 1.8V to 5.5V, with an efficiency of up to 90%

• LINEAR dn414f handbook

  The new LT®6000 family of 1µA and 13µA op amps operates on supplies as high as 16V all the way down to 1.8V, guaranteed over temperature.

• LINEAR dn415f handbook

  This design note introduces the USB power manager with PowerPath Control, which offers the fastest charge time with the lowest heat.

• LINEAR dn412f handbook

  This document introduces the LT3681 switch power supply chip, which integrates switch tube, Schottky diode and controller. The input voltage range is 3.6V-34V, supports 2A current, and has high efficiency. The switching frequency can be adjusted.

• LINEAR dn418f handbook

  This document introduces a high linearity direct conversion receiver design method that uses high performance analog integrated circuits to achieve high linearity, low noise and good I-Q channel matching.

• LINEAR dn398f handbook

• LINEAR dn419f handbook

  The LTC3446 is a single-chip triple-output voltage regulator that integrates a 1A synchronous buck regulator and two 300mA ultra-low dropout linear regulators to provide up to three stepped-down output voltages of 3.3V, 1.8V, and 0.8V from a single input voltage.

• LINEAR dn420f handbook

• LINEAR dn421f handbook

  This document describes the LTC4215-1 chip, which integrates three GPIO lines and an ADC to monitor the board voltage and current. It can provide switch control and status information through GPIO for power management.

• LINEAR dn422f handbook

  The LTC3219 9-output universal LED (ULED) driver is a small and powerful LED driver that can be programmed via the I2C bus interface to individually  grade, blink or turn on nine individual LEDs using internal logic and circuitry to drive nine 6-bit DAC-controlled LED current sources.

• LINEAR dn423f handbook

  The LTC6102 is an ultraprecise current sense amplifier that dramatically enhances efficiency and dynamic range. It features an input error as low as 10μV, enabling a measurement dynamic range of 16 bits while reducing power dissipation in the sense resistor.

• LINEAR dn1013f handbook

  This design note explains the effect of clock jitter on high speed ADCs and uses LTC2209 as an example to show how to select a proper clock to mitigate the effect of clock jitter.

• LINEAR dn424f handbook

  The LTC3785 is a high-efficiency, low-cost, single-ended DC/DC converter controller from Linear Technology. It uses a high-efficiency synchronous boost/buck topology and offers high efficiency, low EMI, low dropout voltage, and low start-up current. It is well-suited for battery-powered handheld applications.

• LINEAR dn425f handbook

  The LTC4268-1 is a solution that integrates a high-power PD interface control with an isolated flyback controller, suitable for high-power 2-pair PoE applications. It provides the same 25k signature detection resistance as standard PoE, and has low inrush current limit and high input current limit.

• LINEAR dn426f handbook

  This design note introduces the features and characteristics of the 6-channel SAR ADC LTC2351-14, including the sampling rate, power consumption, and package. The device is suitable for applications such as 3-phase power line monitoring, portable power line instrumentation, power factor correction, motor control, and data acquisition.