Intersil manuals, page 6
intersil ISL6118 handbook
ISL6118 is a dual channel, fully independent overcurrent (OC) fault protection IC for the +2.5V to +5.5V environment. This device features internal current monitoring, accurate current limiting, integrated power switches and current limited delay to latch-off for system protection. The ISL6118 current sense and limiting circuitry sets the current limit to a nominal 0.6A, which is well suited for the 3.3V AUX ACPI application. The ISL6118 is the ideal companion chip to the HIP1011D and HIP1011E dual PCI hot plug controllers. Together these and the ISL6118 fully control the four legacy PCI voltages (±12V, +3.3V, +5V) and the 3.3V AUX, respectively, for power control of two PCI slots compliant to PCI Bus Power Management Interface Spec Rev 1.1. Designed to be co-located with the HIP1011D on the motherboard, the ISL6118 provides OC fault notification, accurate current limiting and a consistent timed latch-off thus isolating and protecting the voltage bus in the presence of an OC event or short circuit during all PCI Bus Power States as defined by the PCI specification. The 12ms time to latch-off prevents the voltage bus from overcurrenting due to an OC event or short circuit, thus protecting the system and equipment.
intersil ISL1558 handbook
The ISL1558 is an Intersil quad operational amplifier designed for VDSL2 and ADSL2+ line driving in DMT based solutions. It features a high drive capability of 750mA while consuming only 6mA of supply current per amplifier at low bias and operating from a single 4.5V to 12V supply. The driver achieves a typical distortion of -80dBc, at 200kHz into a 50Ω differential load.
intersil ISL1219 handbook
ISL1219 is a low power real time clock/calendar with Event Detect and Time Stamp function, timing and crystal compensation, clock/calendar, power fail indicator, periodic or polled alarm, intelligent battery backup switching and 2 Bytes of battery-backed user SRAM.
intersil ISL1208 handbook
intersil ISL1540 handbook
The ISL1540 is a -52V dual channel differential amplifier designed for driving full rate ADSL signals at very low power dissipation. The high supply voltage allows operation from a single standard -52V negative battery supply. It contains two pairs of wideband, high voltage, current mode feedback amplifiers optimized for lower power consumption and highest performance in ADSL and ADSL2+ systems. The line drivers have fixed gain AV = 48 with integrated feedback and gain resistors. Its output clamping circuit eliminates the requirement for the Zener protection diodes. These drivers achieve an MTPR distortion measurement of better than 70dB while consuming typically 3mA per DSL channel of total supply current.
intersil ISL12028 handbook(1)
ISL12028 is a low power real time clock with clock/calender, power-fail indicator, clock output and crystal compensation, two periodic or polled alarms (CMOS output), intelligent battery backup switching, CPU Supervisor, integrated 512 x 8 bit EEPROM configured in 16 Byte per page.
intersil ISL12029 handbook(1)
The ISL12029 device is a low power real time clock with clock/calender, power-fail indicator, clock output and crystal compensation, two periodic or polled alarms (open drain output), intelligent battery backup switching, CPU Supervisor, integrated 512 x 8 bit EEPROM configured in 16 byte per page. The oscillator uses an external, low-cost 32.768kHz crystal. The real time clock tracks time with separate registers for hours, minutes, and seconds. The device has calendar registers for date, month, year and day of the week. The calendar is accurate through 2099, with automatic leap year correction.
intersil ISL12029 handbook(2)
ISL12029 is a low power real time clock/calendar chip from ISL. It contains clock/calendar, power-fail indicator, clock output and crystal compensation, two periodic or polled alarms (open drain output), intelligent battery backup switching, CPU Supervisor, integrated 512 x 8 bit EEPROM configured in 16 byte per page. The oscillator uses an external, low-cost 32.768kHz crystal. The real time clock tracks time with separate registers for hours, minutes, and seconds. The device has calendar registers for date, month, year and day of the week. The calendar is accurate through 2099, with automatic leap year correction.
intersil ISL12029 handbook
intersil ISL12028 handbook(2)
The ISL12028 is a low power real time clock/calendar with integrated 512 x 8 bit EEPROM, and features clock/calendar, power-fail indicator, clock output and crystal compensation, two periodic or polled alarms (CMOS output), intelligent battery backup switching, CPU Supervisor, etc.
intersil ISL12028 handbook
The ISL12028 is a low power Real Time Clock (RTC) module with clock/calendar, power-fail indicator, clock output and crystal compensation, two periodic or polled alarms (CMOS output), intelligent battery backup switching, CPU Supervisor, integrated 512 x 8 bit EEPROM configured in 16 Byte per page.
intersil ISL12028handbook
ISL12028 is a low power real time clock with clock/calendar, power-fail indicator, clock output and crystal compensation, two periodic or polled alarms (CMOS output), intelligent battery backup switching, CPU Supervisor, integrated 512 x 8 bit EEPROM configured in 16 Byte per page. The oscillator uses an external, low-cost 32.768kHz crystal. The real time clock tracks time with separate registers for hours, minutes, and seconds. The device has calendar registers for date, month, year and day of the week. The calendar is accurate through 2099, with automatic leap year correction.
intersil ISL12027 handbook
ISL12027 is a low power real time clock/calendar with EEPROM from ISL. It has two programmable periodic or polled timers, integrated battery backup, and 512 x 8 bit EEPROM.
intersil 80C88 CMOS 8/16-Bit Microprocessor handbook
80C88 is a high performance 8/16-bit CMOS CPU manufactured using a self-aligned silicon gate CMOS process (Scaled SAJI IV). Two modes of operation, MINimum for small systems and MAXimum for larger applications such as multiprocessing, allow user configuration to achieve the highest performance level.
intersil 80C86 CMOS 16-Bit Microprocessor handbook
This document describes the features and characteristics of the Intersil 80C86 CMOS 16-bit microprocessor, including compatibility with NMOS 8086, completely static CMOS design, low power operation, 1MB direct memory addressing capability, various addressing modes, and arithmetic operations.