Key facts
- Manuals
- 1
- Languages
- ZH
- Last added
- 2012-03-13
Featured 电池保护器AP-61131安装使用说明书 manuals
AN-POWER AP-61131 Battery Protector Installation Manual
This manual describes the AP-61131 battery protector’s key features, including MOSFET control, low‑loss design, and automatic over‑voltage protection for 12 V battery systems. It explains the default cut‑off voltage (10 V) and reset voltage (11.5 V) and provides a wiring diagram with recommended cable sizes and current limits.
The document gives step‑by‑step installation instructions, covering mounting plate preparation, jumper‑setting tables, and connection of input and output leads. Safety warnings advise against mounting the protector on the engine or moving parts and recommend using protective gear during installation. Warranty and contact information are also included. This manual is written in Chinese.
Covers: Features · Important Information · Warnings · Installation Steps · Wire Specification Table · Mounting Plate Pre‑drilled Holes
Latest 电池保护器AP-61131安装使用说明书 manuals
AN-POWER AP-61131 Battery Protector Installation Manual
Installation Guide 2 pages · 254 KB · ZHThe AN-POWER AP-61131 Battery Protector Installation Manual provides features, wiring, voltage settings, and safety warnings for 12 V systems.
Which document do I need?
Installation Guide
Mounting, wiring and first power-up. Read it before the hardware goes in.
Questions answered in 电池保护器AP-61131安装使用说明书 manuals
What is the default cut‑off voltage of the AP‑61131?
The default cut‑off voltage is 10 V.
From: AN-POWER AP-61131 Battery Protector Installation Manual
Can the battery protector be installed on the engine?
No, the protector must not be installed on the engine or any moving parts.
From: AN-POWER AP-61131 Battery Protector Installation Manual