This page provides manuals, user guides, handbooks, instructions, specification, instruction, maintenance manual for ST Anti-Theft Devices, Electronic Original, ...
STEVAL-IHP002V2 is a smartplug system from STMicroelectronics based on STM32F103CB microcontroller, ST7540 PLM module and STPM01 mono-phase energy metering IC, which is used to measure and control AC loads.
This datasheet introduces the features and characteristics of STEVAL-IHM023V2 1 kW 3-phase motor control demonstration board, including voltage range, output power, control method, etc.
This document is a data brief about Keil™ starter kit for STM32F2 series microcontrollers (STM32F207IG MCU). It introduces the features and characteristics of this product.
This data brief introduces the features of the ANT1-M24LR16E antenna reference board, including a 45 mm x 75 mm 13.56 MHz inductive antenna, an M24LR16E-R dual interface EEPROM, an I2C connector, an energy harvesting output (VOUT) and an RF WIP/BUSY output.
The ANT2-M24LR16E antenna reference board is a ready-to-use PCB that features an M24LR16E-R Dual Interface EEPROM IC connected to a 20 mm x 40 mm 13.56 MHz etched RF antenna on one side, and to an I2C bus on the other side.
This data brief introduces the STEVAL-ISA082V1, a 4A peak 800 kHz fixed-frequency PWM synchronous step-down demonstration board with enable on/off based on the ST1S40IPHR. The board operates from 4 V to 18 V input, while it regulates an output voltage as low as 0.8 V and up to VIN (100% duty cycle). It has a short-circuit protected and is RoHS compliant.
The STEVAL-ISA083V1 is a demonstration board for an 800 kHz fixed-frequency PWM synchronous step-down converter based on the ST1S40IPUR. It features a peak output current of 4A, enable on/off based on the ST1S40IPUR, and short-circuit protection.
This file introduces the STEVAL-ILL042V1 LED driver, which uses L6562AT and TSM101 controllers. This driver has high power factor, wide input voltage range, low output voltage ripple and high efficiency.
The STEVAL-PCC009V4 is a demonstration board based on STM32 that is used as an interface between PC and motor control systems. It has an 8-pin interface for SPI/I2C/UART and 6 GPIOs. Opto-isolation is used for SPI, USART, and GPIOs, while magnetic isolation is used for I2C. The board complies with RoHS.
This document describes the features of the 10W+10W class-D audio amplifier demonstration board based on the TDA7491P, including continuous output power, operating voltage range, high efficiency, selectable gain settings, differential inputs, filterless operation, etc.
This data brief introduces the features of the 70 W electronic ballast for metal halide lamp (HID) based on the L6382D5 and ST7FLITE49K2, including minimum mains voltage (rms value), maximum mains voltage (rms value), minimum mains frequency (fmin), etc.
This data brief provides detailed information on the STEVAL-ILL039V1 demonstration board, which is a step-up current controller for 2 LEDs based on the STLDC08 driver. It features an input voltage of 0.8 V to 3.6 V, an output of 2 LEDs at 200 mA, a dimming mode with external PWM signal and is RoHS compliant.
This document introduces the features of the STEVAL-ILL038V1 LED resonant driver demonstration board based on the L6585DE, including extended input mains range, output voltage, long-life electrolytic capacitors, mains harmonics, efficiency, etc.
