ANALOG Manuals

The ADD8708 is an 18-channel integrated gamma reference for use in high resolution LCD TV and monitors panels. The output buffers feature high current drive and low offset voltage to provide an accurate and stable gamma curve. The top nine channels swing to VDD; the lower nine channels swing to GND.

The OP215 is a dual precision JFET-input operational amplifier produced by Analog Devices in the United States. It features high slew rate, low input bias current, low input offset voltage, and low input noise current.

The ADD8706 is a single-supply, 5-channel buffer with a separate VCOM amplifier that has been optimized for today’s low cost TFT LCD notebook and monitor panels. The top and bottom channels swing to the top/bottom rails, respectively, and can be used as end-point gamma references. The middle channels are ideal for midpoint gamma references. The VCOM amplifier has a peak output current of 250 mA and can drive high impedance loads.

AD9662 is a laser diode driver for high performance CD and DVD recordable drives. It includes three channels for three different optical power levels: the read channel generates a continuous output power level, whereas Channel 2 and Channel 3 are used as write channels having 0.8 ns rise/fall times. All channel currents are summed at the IOUT pin. Each channel’s output current is established by multiplying the channel’s input current and a current gain, where the current gain is controlled by the input current. The device is suitable for CD-RW, DVD-RW, DVD+RW and MO drives.

The AD8393 is a low power, high output current, single-supply, ADSL-CO line driver that features ADI’s patent pending Adaptive Linear Power architecture. It has 4 power modes, and can achieve over 36V p-p differential output while processing signals with occasional peaks.

The AD8013 is a low power, single supply, triple video amplifier. Each of the three amplifiers has 30 mA of output current, and is optimized for driving one back terminated video load. It features excellent video specifications (RL = 150 Ohms), gain flatness of 0.1 dB to 60 MHz, differential gain error of 0.02%, and differential phase error of 0.06°.

The OP220 is a monolithic dual operational amplifier that can be used either in single or dual supply operation. Its low offset voltage and input offset voltage tracking (as low as 1.0 mV/∞C) make it the first micropower precision dual operational amplifier. Its excellent specifications make it very attractive in portable applications.

The AD8391 is an xDSL line driver amplifier designed for single-supply xDSL systems. It operates on a voltage range of 3V to 12V and provides low distortion signals. It is suitable for low power applications such as line powered and battery backup systems. The amplifier outputs more than 250mA of current while maintaining -82dBc of SFDR at 100kHz on 12V. It also features a flexible power-down function controlled by a digital control line.

AD848/AD849 are high performance, low power monolithic operational amplifiers. AD848 is internally compensated for stable operation with closed-loop gains of 5 or greater. AD849 is fully decompensated for higher open-loop gains up to 63 dB.

This document is a datasheet for the EVAL-ADDIFFAMP evaluation board which is a flexible board that can be used with a variety of circuit configurations.

AD8130/AD8129 are high-performance differential receiver amplifiers operating at up to 270 MHz, with low noise, high input impedance, high common-mode rejection ratio, and low distortion.