Industrial Manuals

The M627XXML/SL is a low voltage detector designed for detection of a supply voltage and generation of a system reset pulse for almost all logic circuits such as microprocessor. It also has extensive applications including battery checking, level detecting and waveform shaping circuits.

File format: PDF Size:20 KB

M5M54R16AJ,ATP-10,-12,-15 is a family of 262144-word by 16-bit static RAMs, fabricated with the high performance CMOS process and designed for high speed application. These devices operate on a single 3.3V supply, and are directly TTL compatible. They include a power down feature as well.

File format: PDF Size:64 KB

The M54HC4538/M74HC4538 is a high performance CMOS bistable multivibrator fabricated in silicon gate C2MOS technology. It has the same high performance as LSTTL combined with true CMOS low power consumption. Each multivibrator features both a negative, A, and a positive, B, edge triggered input, either of which can be used as an inhibit input. Also included is a clear input that when taken low resets the one shot. The monostable multivibrators are retriggerable. That is, they may be triggered repeatedly while their outputs are generating a pulse and the pulse will be extended. Pulse width stability over a wide range of temperature and supply is achieved using linear CMOS techniques. The output pulse equation is simply PW = 0.7 (R)(C) where R is the output resistance and C is the output capacitance.

File format: PDF Size:277 KB

M54671SP is a stepper motor driver IC from Mitsubishi Electric that drives bipolar stepper motors directly by controlling the coil current with the constant current method. It features a wide output current control range of 20-1200mA and is built in a thermal shutdown circuit. It is used in office automation equipment such as printers, FDDs, HDDs, and FAXes.

File format: PDF Size:74 KB

File format: PDF Size:558 KB

This Application Note describes the performance comparison and benchmark of the Agilent 2200 TapeStation system with the Agilent 2100 Bioanalyzer system, the industry standard for RNA quality control. The 2200 TapeStation system performs automated analysis of up to 96 samples with approximate analysis time of 1 minute per sample. This Application Note demonstrates the high correlation between RINe generated by the 2200 TapeStation system with the RIN quality assessment of the 2100 Bioanalyzer system. The high reproducibility of RINe achieved with the 2200 TapeStation system in RNA quality assessment is also shown. The 2200 TapeStation system is, therefore, a reliable system for RNA quality control.

File format: PDF Size:950 KB

Gene expression analysis is currently carried out using three methods that provide complementary data: microarrays, RNA-Seq, and RT-qPCR. Microarrays provide comprehensive whole-genome coverage in single experiments, with rapid data acquisition and results at a low price per sample.

File format: PDF Size:417 KB

This application note demonstrates the concordance in the results achieved with identical oligonucleotide probes on two versions of Agilent miRNA microarrays [(AMADID 021827, release 12.0) and (AMADID 031181, release 16.0)], based on different revisions of the miRBase database and provided on different microarray formats. Since probes for a given microarray will remain constant for subsequent versions of Agilent SurePrint G3 Human miRNA microarrays, barring any miRBase sequence changes, it is necessary to confirm that the TotalGeneSignal achieved is consistent. The data show Agilent’s strength in probe reproducibility, a crucial factor for identifying miRNA of differential expression.

File format: PDF Size:238 KB

This applications note describes using VnmrJ 3 Software to set up advanced experiments to resolve overlapping homonuclear resonances. These tools allow even novice users to gain critical information about their research samples, using the most advanced NMR experiments available.

File format: PDF Size:848 KB

This application note describes a method for characterizing olive oil using Agilent GC/Q-TOF MS and Mass Profiler Professional software. The method can detect a large number of compounds in olive oil and perform quantitative analysis.

File format: PDF Size:1395 KB

Solid-phase extraction (SPE) coupled with high-performance liquid chromatography (HPLC) was optimized for extraction and quantification of two fungicides (carbendazim and thiabendazole) in apple juice. Results indicate that SPE using Agilent Bond Elut SCX (60 mg, 3 mL) and HPLC using an Agilent ZORBAX Eclipse Plus C18 column (4.6 mm × 100 mm, 3.5 µm) is an excellent combination for extraction and analysis of these compounds. Recoveries ranged from 92.1 to 99.4 percent with RSDs below 5 percent and limits of detection of 4 µg/kg.

File format: PDF Size:527 KB

This application note describes the optimization of a rapid LC/MS/MS method for vitamin B related compounds (4-aminobenzoic acid, nicotinamide, riboflavin, and nicotinic acid) on an Agilent ZORBAX Rapid Resolution High Definition HILIC Plus column using an Agilent 1290 Infinity LC System with an Agilent 6410A Triple Quadrupole Mass Spectrometer. The method uses isocratic elution with an acetonitrile rich mobile phase and an ammonium acetate buffer. All analytes have good peak shape with this hydrophilic interaction chromatography (HILIC) application. The method is then used to demonstrate the importance of choosing an appropriate injection solvent when performing LC analyses in HILIC mode. Various injection solvents are investigated, including water, acetonitrile, methanol, and combinations. Of the solvents explored, it was determined that pure acetonitrile yields the best retention and peak shape for all compounds, with water being the worst solvent for analytical performance and peak shape.

File format: PDF Size:692 KB

Summary of the characteristics of M29F800DT M29F800DB 8 Mbit (1Mb x8 or 512Kb x16, Boot Block) 5V Supply Flash Memory.

File format: PDF Size:211 KB

This application note uses Agilent ZORBAX RRHD columns with UHPLC/MS to compare Morphine’s HILIC and RPLC. Both methods use acetonitrile/ammonium acetate buffer mobile phase for isocratic elution. The results show that HILIC mode allows for more sensitive MS detection due to more efficient spraying and desolvation in the ESI-MS source, as a result of the volatile acetonitrile rich mobile phase used.

File format: PDF Size:1037 KB

This document describes the advantages and disadvantages of copper and molybdenum sources on a dual source SuperNova diffractometer, and compares the two sources in terms of data collection and data processing.

File format: PDF Size:130 KB

This application note describes an analytical method for determination of carbendazim and 3 other fungicide residues in orange juice with easy sample preparation and LC/MS/MS detection. Developed for the 3 most important systemic fungicides, carbendazim, thiabendazole, and imazalil with its metabolite, this method can be easily expanded to include a broader range of pesticides. A simple and rapid extraction procedure provides clean extracts that without any preconcentration allow for detection of analytes at concentrations below 2 ppb. Quantification was performed using triphenyl phosphate as an internal standard. Excellent accuracy (% recovery) and precision (% CV) data were obtained for three concentration levels: 10, 50, and 250 ppb of each analyte.

File format: PDF Size:694 KB

M28C64 is a 64Kbit (8K x 8) parallel EEPROM with software data protection. Its features are fast access time, single supply voltage, low power consumption, fast byte and page write, enhanced write detection and monitoring, JEDEC approved bytewide pin-out, software data protection, 100000 erase/write cycles (minimum) and data retention (minimum): 40 years for M28C64 and M28C64-xxW, 10 years for M28C64-A.

File format: PDF Size:157 KB

This application note describes a rigorous QC column testing approach that employs active tests probes to verify the inertness performance of modern GC capillary columns.

File format: PDF Size:781 KB

An Agilent 1290 Infinity LC System is optimized for the lowest possible extra-column volume, to ensure minimal band broadening and optimal results from a small dimension, Agilent ZORBAX RRHD Eclipse Plus C18, 2.1 × 50 mm, 1.8 µm column. Improvements to isocratic and gradient analyses are evident, with the early eluting peaks from the isocratic analysis showing the greatest improvement of up to a 58% increase in efficiency (k’ = 1.6). Gradient analyses are improved by 24 to 32% with respect to conditional peak capacity (k’ = 1.3 to 5.3). Additionally, there is no strong correlation between flow rate and the effect of extra-column volume, with respect to column performance for isocratic and gradient analyses.

File format: PDF Size:823 KB

This document introduces how to detect synthetic cannabinoids in oral fluid

File format: PDF Size:724 KB