Key facts
- Manuals
- 4
- Languages
- ZH · EN
- Last added
- 2012-07-03
Featured Application manuals
National Semiconductor DS90CR218A and LM98714 Application Note 1538
This application note explains how the National Semiconductor DS90CR218A LVDS channel‑link receiver works together with the LM98714 16‑bit, 45 MSPS analog front‑end to form a high‑performance LVDS data link for image sensors such as CCD/CIS. It covers the system architecture, LVDS advantages, timing considerations, and PCB layout recommendations.
The document provides design guidance on setup time, hold time, receiver offset margin (RSKM), and termination requirements, and includes reference tables and typical values for engineers designing LVDS interfaces. This manual is written in Chinese.
Covers: Introduction · System Block Diagram · Advantages of LVDS · System Adjustment · PCB Layout Guidelines · References
Carmar WT OO—OOO0O Linear Scale Installation Guide
The Application & Installation Guide explains how to safely install and operate the Carmar WT OO—OOO0O linear scale. It covers working conditions, handling precautions, and step‑by‑step installation procedures, including cable routing and read‑head positioning.
Technical specifications such as resolution, effective travel range, voltage, and signal output modes are listed, and the document also details daily maintenance, warranty information, and troubleshooting tips.
Covers: Preface · Principle and Application · Specification · Installation Guidelines · Output Signal · Maintenance
Latest Application manuals
Application 265-00 Agilent Monomer Analyzer service manual
Agilent Monomer Analyzer is a monomer analyzer launched by Agilent Technologies. It uses dual flame ionization detectors (FID) for detection, with a lower detection limit of 2 ppm and an analysis time of approximately 25 minutes.
National Semiconductor DS90CR218A and LM98714 Application Note 1538
Application Note 6 pages · 381 KB · ZHApplication note describing the LVDS interface between National Semiconductor DS90CR218A receiver and LM98714 AFE.
Carmar WT OO—OOO0O Linear Scale Installation Guide
Installation Guide 19 pages · 232 KB · ENThis guide provides installation, wiring, and maintenance instructions for the Carmar WT OO—OOO0O linear scale.
Application Note-004 CIE-H10 string Switch 1.0 Manual
Which document do I need?
Application Note
How to use the product for one specific task, with worked examples.
Installation Guide
Mounting, wiring and first power-up. Read it before the hardware goes in.
Questions answered in Application manuals
What is the typical RSKM value when LM98714 is used as a transmitter?
The typical receiver offset margin (RSKM) is 0.968 ns.
From: National Semiconductor DS90CR218A and LM98714 Application Note 1538
What termination resistor value is recommended for the DS90CR218A?
A typical termination resistor value is 100 Ω.
From: National Semiconductor DS90CR218A and LM98714 Application Note 1538
What is the recommended operating temperature range?
The linear scale operates between 0 °C and 40 °C.
How far should the read‑head be positioned from the scale body?
The interval between the read‑head and the body should be 0.8 mm to 1.6 mm.