Key facts
- Manuals
- 1
- Languages
- ZH
- Last added
- 2000-01-01
Featured 6308DT manuals
Jenco 6308DT DO/Temperature Controller User Manual
The Jenco 6308DT is a micro‑computer based DO and temperature controller designed for use in humid environments. It features a self‑check on power‑up, EEPROM storage of calibration data, and a 128×64 graphic LCD that can display DO, temperature, salinity compensation, and isolation current.
The manual covers product inspection, installation, wiring, operation modes, calibration procedures, relay settings, 4‑20 mA current output configuration, RS‑485 communication, troubleshooting, and warranty information. This manual is written in Chinese.
Covers: Introduction · Product Inspection and Installation · Operation and Use · Display Modes · DO Probe Calibration · Relay and Control Information
Latest 6308DT manuals
Jenco 6308DT DO/Temperature Controller User Manual
User Manual 24 pages · 162 KB · ZHOperation manual for the Jenco 6308DT controller that measures dissolved oxygen and temperature with RS‑485 and 4‑20 mA outputs.
Which document do I need?
User Manual
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in 6308DT manuals
How do I power on the controller?
Connect the unit to the correct AC supply (115 VAC or 230 VAC, 50/60 Hz); it will perform a self‑check and start automatically.
How can I calibrate the dissolved‑oxygen probe?
Enter calibration mode via the [CAL/VIEW] key; you can perform single‑point or two‑point calibration, and the values are stored in EEPROM.