TOSHIBA Manuals

The TC74VCXR162245FT is a high-performance CMOS 16-bit bus transceiver produced by Toshiba Corporation. This transceiver is designed for use in 1.8-V, 2.5-V or 3.3-V systems, while maintaining CMOS low power dissipation and achieving high-speed operation. It is also designed with overvoltage tolerant inputs and outputs up to 3.6 V. This 16 bit bus transceiver is controlled by direction control (DIR) inputs and output enable (OE) inputs which are common to each byte. It can be used as two 8-bit transceivers or one 16-bit transceiver. The direction of data transmission is determined by the level of the DIR inputs. The OE inputs can be used to disable the device so that the busses are effectively isolated. The 26-Ω series resistor helps reducing output overshoot and undershoot without external resistor. All inputs are equipped with protection circuits against static discharge.

TC74AC112P/F/FN is an advanced high speed CMOS DUAL J-K FLIP FLOP fabricated with silicon gate and double-layer metal wiring C2MOS technology. It achieves the high speed operation similar to equivalent Bipolar Schottky TTL while maintaining the CMOS low power dissipation.

TC74VCX32FT/FK is a high-performance CMOS 2-input OR gate which is guaranteed to operate from 1.2-V to 3.6-V. Designed for use in 1.5V, 1.8V, 2.5V or 3.3V systems, it achieves high-speed operation while maintaining the CMOS low power dissipation. It is also designed with overvoltage tolerant inputs and outputs up to 3.6 V. All inputs are equipped with protection circuits against static discharge.

The TC74VCX16543FT is a 16-bit registered transceiver from Toshiba Corporation. It is designed for use in 1.8-V, 2.5-V or 3.3-V systems and achieves high-speed operation while maintaining low power dissipation. The device also has overvoltage tolerant inputs and outputs up to 3.6 V. The TC74VCX16543FT can be used as two 8-bit transceivers or one 16-bit transceiver. Separate latch-enable (LEAB or LEBA) and output-enable (OEAB or OEBA) inputs are provided for each register to allow independent control in either direction of data flow. The A-to-B enable (CEAB) input must be low in order to enter data from A or to output data from B. If CEAB is low and LEAB is low, the A-to-B latches are transparent; a subsequent low-to-high transition of LEAB puts the A latches in the storage mode. With CEAB and OEAB both low, the 3-state B outputs are active and reflect the data present at the output of the A latches. Data flow from B to A is similar but requires using the CEBA, LEBA, and OEAB inputs. When the OE input is high, the outputs are in a high-impedance state. This device is designed for use with 3-state memory address drivers, etc. All inputs are equipped with protection circuits against static discharge.

TC7WZ74FU/FK is a D-Type Flip Flop with Preset and Clear chip produced by Toshiba. Its features include high output current, super high speed operation, wide operating voltage range, 5.5-V Tolerant inputs, 5.5-V Power down protection outputs, etc.

The TC7WZ245FU/FK is a dual bus transceiver produced by Toshiba. It has high output current (±24mA), super high speed operation (tpd=5.0ns) and 5.5V tolerant inputs.

TC74ACT299P/F is a high-performance CMOS 8-bit PIPO shift register produced by TOSHIBA. It has high speed and low power consumption, and can be used as a TTL or NMOS to high-speed CMOS interface converter.

The TC74VCX14FT/FK is a low-voltage hex schmitt inverter produced by TOSHIBA. Its features are: operating voltage between 1.2V to 3.6V, high speed, low power consumption, and over-voltage protection.

The TC74ACT164 is an advanced high speed CMOS 8-BIT SERIAL-IN PARALLEL-OUT SHIFT REGISTER fabricated with silicon gate and double-layer metal wiring C2MOS technology. It achieves the high speed operation similar to equivalent Bipolar Schottky TTL while maintaining the CMOS low power dissipation.

The TC7MH573FK is an advanced high speed CMOS octal latch with 3-state output fabricated with silicon gate C2MOS technology. It achieves the high speed operation similar to equivalent bipolar schottky TTL while maintaining the CMOS low power dissipation.

The TC74AC151 is an advanced high-speed CMOS 8-CHANNEL MULTIPLEXER fabricated with silicon gate and double-layer metal wiring C2MOS technology. It achieves high-speed operation similar to equivalent Bipolar Schottky TTL while maintaining low power dissipation. One of eight data input signals (D0-D7) is selected by decoding the three-bit address input (A, B, C). The selected data appears on two outputs: non-inverting (Y) and inverting (W). The STROBE input provides two output conditions; a low level on the STROBE input transfers the selected data to the outputs. A high level on the STROBE input sets the Y output low and the W output high without regard to the data or select input conditions. All inputs are equipped with protection circuits against static discharge or transient excess voltage.

The TC74VCX162721FT is a high-performance CMOS 20-bit D-type flip-flop. Designed for use in 1.8V, 2.5V or 3.3V systems, it achieves high-speed operation while maintaining the CMOS low power dissipation. It is also designed with overvoltage tolerant inputs and outputs up to 3.6V. The TC74VCX162721FT is an edge-triggered D-type flip-flop with qualified clock storage. On the positive transition of the clock (CK) input, the device provides true data at the Q outputs if the clock-enable (CKEN) input is low. If CKEN is high, no data is stored. When the OE input is high, the outputs are in a high-impedance state. This device is designed to be used with 3-state memory address drivers, etc. The 26-Ω series resistor helps reducing output overshoot and undershoot without external resistor. All inputs are equipped with protection circuits against static discharge.

The TC7MH273FK is an advanced high speed CMOS octal D-type flip-flop fabricated with silicon gate C2MOS technology. It achieves the high speed operation similar to equivalent bipolar schottky TTL while maintaining the CMOS low power dissipation.

The TC74VCXH16373FT is a low-voltage 16-bit D-type latch produced by Toshiba. This latch has the characteristics of low-voltage operation, bushold input, high-speed operation, low pull current, and anti-static discharge.

The TC74LCX273F/FT/FK is an octal D-type flip-flop from Toshiba that is designed for use in 3.3V systems. It features high-speed operation and low power dissipation. The device is also compatible with 5V supply environments for both inputs and outputs.